RM8000T
RM50T
Floorstanding Loudspeaker
Owner’s
Manual
SPECIFICATIONS*
RM8000T/RM50T
FIGURE 4
Basic Hook-up, recommended for most systems.
BASS MANAGEMENT SETTINGS: Front = Large
TRANSDUCER COMPLEMENT:
4 - 4 1/2"(11.25cm) mid-bass driver
1 - 1"(2.5cm) tweeter
Recomendada para la mayoría de los sistemas.
PARÁMETROS DE CONTROL DE BAJAS FRECUENCIAS: Front = Grande (Large)
Recommandée pour la plupart des systèmes.
OVERALL FREQUENCY
RESPONSE:
Réglages: (Bass Management Settings) Front (avant) = Large
42Hz - 26kHz
Empfohlen für die meisten Lautsprecher.
EINSTELLUNG DER TIEFENTONLAGEN: Vorne = Groß
-3dB LIMITS:
55Hz - 25kHz
POWER AMPLIFIER = amplificatore finale, integrato, o sintoamplificatore
Schema di base per il collegamento dei diffusori acustici RTi.
RECOMMENDED
AMPLIFICATION:
20-200 Watts/channel
FIGURE 5
Bi-wiring, or using separate speaker wire connections
IMPEDANCE:
for high and low frequency sections. Remove flat metal jumpers.
Compatible with 8 ohm output
Bicableado, o uso de conexiones de cables de altavoz
separadas para las secciones de alta y baja frecuencia.
EFFICIENCY @ 2.83 Vrms DRIVE LEVEL:
90dB
Bi-câblage: l’utilisation de câbles distincts pour brancher les
DIMENSIONS:
composantes des hautes et des basses fréquences de vos enceintes.
45.1" H* x 6.2" W x 7.9" D
114.6cm H x 15.8cm W x 20cm D
*Add .6" inches (1.5 cm) to height
for floor spikes.
Verwendung von unterschiedlichen Kabelverbindungen
für hohe und niedrige Frequenzen.
POWER AMPLIFIER = amplificatore finale, integrato, o sintoamplificatore.
Schema di collegamento mediante due cavi separati (“bi-wiring”): ciascuna
delle due sezioni, passa-alto (alte frequenze) e passa-basso (basse frequenze),
del filtro d’incrocio del CSi40 è collegata all'amplificatore mediante un cavo dedicato.
BASE DIMENSIONS:
9.6" W x 13.4" D
24.4cm W x 33.9cm D
SHIPPING WEIGHT:
42 lb, 19.05 kg
FIGURE 6
Bi-amping, or using separate amplifiers for the low and high frequency sections of your speakers.
Remove flat metal jumpers.
Biamplificación, o uso de amplificadores separados para las secciones de baja y alta frecuencia
de los altavoces.
*All specifications subject to
change without notice.
Bi-amplification: l’utilisation d’amplis distincts pour alimenter les composantes des hautes et des
basses fréquences de vos enceintes.
Verwendung von unterschiedlichen Verstärkern für niedrige und hohe Frequenzen der Lautsprecher.
LOW FREQ. AMPLIFIER = amplificatore finale per la sezione bassi
HIGH FREQ. AMPLIFIER = amplificatore finale per la sezione alti
Schema di collegamento a due amplificatori separati (“bi-amping,” doppia amplificazione): uno dedicato alla sezione passa-alto (alte frequenze), l'altro a quella
passa-basso (basse frequenze) del filtro d'incrocio del CSi40. Notate che i morsetti superiori del diffusore acustico appartengono alla sezione alte frequenze del
filtro (ndt.).
FIGURE 7
Clean aluminum finish and composite endcaps with a damp cloth.
Do not use furniture polish on aluminum finish and composite endcaps.
Cuidado del acabado de madera natural.
Entretien de la finition en bois véritable.
Pflege der Holzappretur.
Non impiegate prodotti lucidanti per mobili
sulla finitura, ma spolveratela soltanto con
un panno umido.
Polk Audio Customer Service: 1-800-377-7655 (Outside US & Canada: 410-358-3600) Monday-Friday, 9:00 AM-6:00 PM EST, [email protected]
NOTES
LIMITED FIVE YEAR WARRANTY
Polk Audio, Inc., warrants to the original retail purchaser only. This warranty will terminate automatically prior to its stated expiration if the original retail purchaser sells or transfers
the Product to any other party.
Polk Audio, Inc., warrants, to the original retail purchaser only, that the LOUDSPEAKER(S), PASSIVE CROSSOVER COMPONENT(S) and ENCLOSURE on this Polk Audio Loudspeaker
Product will be free from defects in material and workmanship for a period of five (5) years from the date of original retail purchase from a Polk Audio Authorized Dealer.
Furthermore, Polk Audio, Inc., warrants, to the original retail purchaser only, that any AMPLIFIER OR OTHER ELECTRONIC COMPONENT that may be included in this Polk Audio Loudspeaker Product
will be free from defects in material and workmanship for a period of three (3) years years from the date of original retail purchase from a Polk Audio Authorized Dealer.
in the USA and Canada (outside the USA: 410-358-3600) within ten (10) days of the date of original purchase. Be sure to keep your original purchase receipt.
Defective Products must be shipped, together with proof of purchase, prepaid insured to the Polk Audio Authorized Dealer from whom you purchased the Product, or to the Factory at 2550 Britannia Boulevard,
Suite A, San Diego, California 92154. Products must be shipped in the original shipping container or its equivalent; in any case the risk of loss or damage in transit
is to be borne by you. If upon examination at the Factory or Polk Audio Authorized Dealer it is determined that the unit was defective in materials or workmanship at any time during this Warranty period, Polk
Audio or the Polk Audio Authorized Dealer will, at its option, repair or replace this Product at no additional charge, except as set forth below. All replaced parts and Products become the property of Polk Audio.
Products replaced or repaired under this warranty will be returned to you, within a reasonable time, freight prepaid.
This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures, commercial use, voltage inputs
in excess of the rated maximum of the unit, cosmetic appearance of cabinetry not directly attributable to defect in materials or workmanship, or service, repair, or modification
of the Product which has not been authorized or approved by Polk Audio. This warranty shall terminate if the Serial number on the Product has been removed, tampered with or defaced.
This warranty is in lieu of all other expressed Warranties. If this Product is defective in materials or workmanship as warranted above, your sole remedy shall be repair or replacement
as provided above. In no event will Polk Audio, Inc. be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. or a Polk Audio
Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above
limitation and exclusion may not apply to you.
All implied warranties on this Product are limited to the duration of this expressed Warranty. Some states do not allow limitation on how long an implied Warranty lasts, so the above
limitations may not apply to you. This Warranty gives you specific legal rights, and you also may have other rights which vary from state to state.
This Warranty applies only to Products purchased in Canada, the United States of America, its possessions, and U.S. and NATO armed forces exchanges and audio clubs.
The Warranty terms and conditions applicable to Products purchased in other countries are available from the Polk Audio Authorized Distributors in such countries.
Polk Audio Customer Service: 1-800-377-7655 (Outside US & Canada: 410-358-3600) Monday-Friday, 9:00 AM-6:00 PM EST, [email protected]
5601 METRO DRIVE
BALTIMORE, MARYLAND 21215
800-377-7655 (US & CAN, OUTSIDE US 410-358-3600)
WWW.POLKAUDIO.COM
“Polk Audio,” “The Speaker Specialists,” “Dynamic Balance” and “Acoustic Resonance Control” are
registered trademarks of Polk Investment Corporation used under license by Polk Audio Incorporated.
RM8006-1
|