DVD-103S
DVD-ROM Drive
OP E R AT I N G IN S T R U C T I O N S
Version 1.00
June 19, 2000
Pioneer Corporation
Pioneer New Media Technologies, Inc.
IMPORTANT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications; there are no guarantees that interference will not occur in a particular
installation. If this drive does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit which is different from the
receiver’s circuit
• Consult the dealer or an experienced radio/TV technician for help
Table of Contents
1.0 General Information......................................................................................................... 2
2.0 Safety Instructions .......................................................................................................... 3
2.1 Drive Precautions .................................................................................................... 3
2.2 Disc Precautions ..................................................................................................... 4
3.0 Features ........................................................................................................................... 4
3.1 Specific Features..................................................................................................... 4
3.2 Precautions With CD-RW/DVD-RW Discs ............................................................... 5
3.3 When Playing 8cm (3.15”) Discs.............................................................................. 5
4.0 Interface ........................................................................................................................... 5
4.1 Front View ............................................................................................................... 6
4.2 Back View................................................................................................................ 6
4.3 Region Code Information......................................................................................... 7
5.0 Installation ....................................................................................................................... 7
5.1 Positioning the Drive................................................................................................ 7
5.2 Connections ............................................................................................................ 8
6.0 Specifications .................................................................................................................. 9
6.1 General Functions ................................................................................................... 9
6.2 Specific Functions ................................................................................................... 9
- i -
DVD-114 Operating Instructions
1.0
GENERAL INFORMATION
Thank you for buying this Pioneer DVD-ROM drive. Please read through these
operating instructions to understand your unit properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
WARNING
: To prevent fire or shock hazard, do not expose drive to rain or moisture.
CAUTION
: This product contains a laser diode of higher class than 1. To ensure
continued safety, do not remove any covers of attempt to gain access to the inside of the
product. Refer all servicing to qualified personnel. For pluggable equipment, install near
a wall outlet for easy access. The drive is labeled as a Class 1 Laser Product on the
top of the cover.
Do not remove the cover. Alterations or modifications carried out without appropriate
authorization may invalidate the warranty.
This product complies with the EMC Directives (89/336/EEC,92/31/EEC) and CE
Marking Directive (93/68/EEC).
The Generation of Acoustical Noise is less then 70dB.
(For Canadian model: This Class B digital apparatus complies with Canadian ICES-003.)
Play only round discs rather than unique shapes such as a heart or diamond.
AFTER SALES SERVICE FOR PIONEER PRODUCTS:
Contact your dealer or distributor for after-sales and warranty service. Please provide
any necessary warranty documents or other pertinent information. If the documents are
unavailable, please contact the Pioneer regional service headquarters listed below.
Please do NOT ship any products to these non-repair center addresses
AMERICA
Pioneer Electronics Service, Inc.
Customer Support Division
P.O. box 1760
Long Beach, CA 90801-1760
EUROPE
Pioneer Electronics (Europe) N V
European Service Division
Haven 1087, Keetbeglaan 1, 19120 Melsele, Belgium
- 2 -
DVD-114 Operating Instructions
ASIAN
Pioneer Electronics Asiacentre PTE Ltd.
Service Department
253 Alexandra Road, #04-01
Singapore 159936
JAPAN & OTHERS
Pioneer Corporation (Head Office)
Customer Support Center
4-1, Meguro 1-Chrome, Meguro-KU, Tokyo 153-8654 Japan
2.0
SAFETY INSTRUCTIONS
To ensure your personal safety and to maximize the full operating potential of your drive,
read and follow the precautions listed below.
2.1
Drive Precautions
This section discusses installation concerns and drive maintenance.
Environment
– Avoid installing this drive in a location with exposure to large
quantities of dust, high temperatures, high humidity, and subject to excessive
vibrations or shocks.
Power
– Turn OFF the system before installing this or any other hardware
device.
Read & Retain Instructions
– Read all operating and user information provided
with this drive.
Cleaning
– Use a damp cloth to clean the exterior housing. Avoid using any
fluids including liquid, aerosol or alcohol-based cleaning products.
Water or Moisture
– avoid operating or locating this drive near water or other
sources of fluid.
Power Sources
– Operate this drive only from the recommended power
sources. If you are unsure of the power source, consult an authorized Pioneer
representative.
Overloading
– Avoid connecting too many devices to a single wall socket or
power source as this can cause fires or short circuits.
Object & Liquid Entry
– Never push objects
Condensation
– Moisture can form in the operating section of the product if the
drive is taken from cool surroundings to a room with a warmer temperature. Let
the drive stand for one to two hours in the new location before turning it ON.
- 3 -
DVD-114 Operating Instructions
Servicing
– Opening or removing the cover exposes you to possible electrical
shock or other danger. Contact a Pioneer authorized service representative for
repairing this drive (refer to the enclosed Service & Support Card).
2.2
Disc Precautions
Cracked or warped discs may damage the drive. If a disc breaks inside of the
unit, pieces are likely to strike the optics.
Non-standard disc shapes are unusable on this drive. These shapes include
hearts, diamonds, polygons, etc.
3.0
FEATURES
The Pioneer DVD-103S drive support many current and upcoming formats.
3.1
Specific Features
•
High-Speed Reading / transfer rate (sustained):
DVD-ROM – maximum 8,100 kBytes/sec.
CD-ROM – maximum 4,800 kBytes/sec.
•
•
Note: The data transfer rate may fail to be output if the disc is scratched or
damaged in any way.
High Speed Access / random average:
DVD-ROM – 120 ms
CD-ROM – 90 ms
•
•
ATAPI correspondence
Buffer size: 512 kBytes
Applicable discs:
•
* DVD-ROM (DVD-5, DVD-9)
* CD-ROM Mode 1
* CD-DA
* CD Extra
* Video CD
* DVD-V
* DVD-R
* CD-RW/DVD-RW disc reading
* CD-ROM XA Mode 2 (Form 1, 2) * CD-R
Note: Please read the following section entitled Precautions with CD-RW/DVD-RW
discs
- 4 -
DVD-114 Operating Instructions
•
•
•
•
•
Correspondence with Kodak Photo CD multi-sessions
Conforming to MPC-3 specifications
Half-height size
Slot loading
Microsoft® Windows® 95 and Windows® 98 (Plug & Play) supported
3.2
Precautions With CD-RW/DVD-RW Discs
This drive is able to read out CD-RW/DVD-RW disc data. The following items
may affect speed or compatibility.
•
•
•
•
The drive requires an additional short period of time to sense a CD-
RW/DVD-RW disc at startup when compared with a CD/DVD-ROM.
Since a CD-RW/DVD-RW signal level is lower than a replicated CD/DVD
disc, reading speeds are slower.
Blank discs, discs without data, and discs without a complete closing
process are invalid.
The drive may fail under the following conditions:
* dirty or scratched discs
* heavily rewritten discs
3.3
When Playing 8cm (3.15”) Discs
To play an 8cm (3.15”) disc, use an adapter designed for this disc size. Before
loading the disc, verity that it is securely in the adapter catches. If the disc is
placed in the slot by mistake, press the Eject button repeatedly until the disc is
forced out of the slot.
Use adapters marked with the standard logo (
cause the disc to idle or to flex.
) only. Avoid adapters that
4.0
INTERFACE
Before connecting the drive, confirm that all cables are present. Verify that the ports are
free from any packing materials and that the drive slot is free of plastic.
- 5 -
DVD-114 Operating Instructions
4.1
Front View
DVD-103S Front View
1) Disc Loading Slot
insert a disc with the label facing
2) Phones – Headphone jack
stereo mini-jack for using headphones
3) Volume Control – Headphone Level
used to adjust the volume for the headphones
4) Busy indicator
flashes during data access
5) Eject button
press to eject a disc
4.2
Back View
DVD-103S Back View
6) Audio Output
connector for analog audio output, uses a Modex 70553 connector
Select the appropriate cable from the following chart:
Pin
1
Name Function
L
Left channel audio output
2
G
G
R
Ground
3
Ground
4
Right channel audio output
- 6 -
DVD-114 Operating Instructions
7) Device Configuration Jumper
set this jumper switch to select the drive use mode supporting the computer
(jumpered = ON; no jumper = OFF)
Pin
1
Name Function
MA*1
on Drive set to Master mode
2
SL
on Drive set to Slave mode
on Drive set to Cable Select mode
Reserved
3
CS
4
5
RPC
on Stays in RPC Phase I mode
SET
off Starts in PRC Phase II mode
never return to Phase I mode
after using Phase II mode
*1 *2
8) Host IDE Interface
40-pin I/O connector in accordance with ATA specifications
9) DC Input
power supply input for DC +5 V and +12 V
Pin
1
Name Function
+12
G
Power supply input for DC +12 V
2
Ground
3
G
Ground
4
+5
Power supply input for DC +5 V
4.3
Region Code Information
5
The maximum number of times the Region Code may be changed is five ( ),
including the initial setting. The fifth change becomes PERMANENT.
Note: Region Codes are part of the DVD Standard, however, Region Codes on DVD
discs are optional. DVD discs with no specified Region Code may be played on any
player.
5.0
INSTALLATION
The following information provides step-by-step instructions to install the DVD-103S.
5.1
Positioning the Drive
Before beginning the installation, decide if the drive needs to be positioned
horizontally (standard) or vertically. Review all instructions prior to install the
DVD-114 drive.
- 7 -
DVD-114 Operating Instructions
1. Turn OFF the computer and remove the cover or front panel.
2. Remove the blank drive-cover from the front panel.
3. Attach the slide rails to the drive.
slide rails may be purchased from a computer retailer
4. Insert the drive in to the open bay/slot.
5. Place the screws in the appropriate holes and tighten.
Screws must be shorter than 5mm (3/16”) in length, longer screws may
damage the drive.
Note: When mounting screws are loose, vibrations from a spinning disc may
cause a ripping sound.
5.2
Connections
The computer provides power for the drive rather than an external power source.
Do not use any other power supply for this drive.
Connect the cables in the following order:
1. Connect the power cable from the computer.
pay close attention to the polarity on the cable
2. Connect the IDE interface cable.
confirm that Pin 1 on the drive corresponds to Pin 1 on the cable
3. Connect the drive’s audio output to the sound card, if applicable
- 8 -
DVD-114 Operating Instructions
6.0
SPECIFICATIONS
6.1
General Functions
12 cm (4.72”) 8 cm (3.15”) *
Disc Diameter
* use an appropriate adapter when playing 8 cm discs
Transfer Rate
(sustained)
DVD-ROM
CD-ROM
Maximum 8,100 kBytes/sec *
Maximum 4,800 kBytes/sec *
* data transfer rate may not be output if disc is damaged or dirty
Access Time
(Random Average)
DVD-ROM
CD-ROM
120 ms
90 ms
Data Butter Capacity
512 kBytes
6.2
Specific Functions
Audio Output Line
0.7 Vrms ± 0.5 Vrms
(at 10 kΩ load)
Power Supply
DC + 12 V, 1.2 A (peak) – 0.8 A (normal)
CD + 5 V, 1.0 A (peak) – 0.8 A (normal)
External Dimensions
(includes front panel)
5 27/32“ (W) x 1 11/16” (H) x 8 7/32” (D)
148mm (W) x 42.3mm (H) x 208.5mm (D)
Weight
2.2 lbs (1.0 kg)
Temperature Range
Humidity Range
41° F to 113° F (+5° C to +45° C)
5% to 85% (no condensation)
Storage Temperature - 40° F to 140° F (- 40° C to +60° C)
Storage Humidity 5% to 90% (no condensation)
Note: Specifications and design changes subject to possible modification without notice due to
improvements.
- 9 -
DVD-114 Operating Instructions
DVD-103S
Industrial DVD-ROM Drive
Pioneer Electronic Corporation
4-1, Meguro 1-chome
Meguro-ku, Tokyo 153
JAPAN
Pioneer New Media Technologies, Inc.
2265 East 220th Street
Long Beach, California 90810
United States of America
(310) 952-2111
- 10 -
|