Philips Work Light L 1250 HPM User Manual

MATERIAL SAFETY DATA SHEET  
PRODUCT: L 1250 - HPM, L 1261 - HPA  
(325779, 305581)  
Revised: 6/01  
SECTION 1: MANUFACTURER  
Manufacturer's Name and Address:  
Philips Lighting Company  
A Division of Philips Electronics  
North America Corporation  
200 Franklin Square Drive  
Somerset, NJ 08875  
Emergency Telephone No.: (800) 424-9300 CHEMTREC  
(732) 563-3197 Environmental  
Other Information Calls:  
(800) PLC-BULB  
SECTION 2: HAZARDOUS INGREDIENTS  
OSHA (PEL)  
ACGIH (TLV)  
.025mg/m38hr.TWA  
< .1mg/m_  
NONE ESTABLISHED  
NONE EST'D  
%
Mercury (7439-97-6)  
.1mg/m3Ceiling  
.05mg/m3  
<.02  
<.02  
<.02  
<.02  
Lead Iodide (10101-63-0) *  
Gallium Iodide (13450-91-4)*  
Cobalt (7440-48-4)+  
.1 mg/m_  
Krypton - 85  
HPM less than 15 nCi;  
HPA less than 50 nCi.  
*HPM Only.  
+HPA Only.  
A division of  
200 Franklin Square Drive  
Philips Electronics North America Corporation  
P.O. Box 6800  
Somerset, NJ 08875-6800  
Tel: 732.563.3000  
L 1250 - HPM, L 1261 - HPA  
 
Page 3 of 5  
SECTION 6: HEALTH HAZARD DATA  
WARNING: THIS LAMP EMITS SHORTWAVE ULTRAVIOLET RADIATION WHICH IS  
HARMFUL TO SKIN AND EYES AND CAN CAUSE SERIOUS SKIN BURNS AND EYE  
INFLAMMATION.  
USE ONLY IN EQUIPMENT SPECIFICALLY DESIGNED TO  
REDUCE THE RISK OF PERSONAL INJURY AND PROPERTY DAMAGE RESULTING  
FROM ARC TUBE RUPTURE AND FROM ULTRAVIOLET RADIATION. IT IS  
RECOMMENDED THAT THIS LAMP BE USED IN FIXTURES HAVING A SAFETY  
INTERLOCK SWITCH. LEAD IODIDE IS NOT LISTED AS A CARCINOGEN BY IARC,  
NTP, OR OSHA.  
------------------------------------------------------------------------------------------------------------------  
FIRST AID: If exposure to ultraviolet radiation occurs, it is recommended that an  
opthamologist be consulted.  
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE  
WASTE DISPOSAL METHOD: The lamp contains a small amount of mercury - together with a  
small amount of lead iodide. Under the toxicity characteristic leaching procedure (TCLP)  
promulgated by the United States E.P.A. tests of used or spent high intensity discharge lamps  
indicate that these lamps generally are considered to be hazardous when discarded. (Fed. Reg.  
7/27/94.) EPA has issued the Universal waste Rule for lamps which fail the TCLP (Fed Reg  
7/6/99). More than thirty States now manage lamps under this Rule. The UWR requires  
recycling or hazardous waste disposal of those lamps which fail TCLP. There are some  
exemptions which depend on your status, volume and or location. Check with your State  
Authorities for information to ensure proper waste disposal practice.  
A division of  
Philips Electronics North America Corporation  
200 Franklin Square Drive  
P.O. Box 6800  
Somerset, NJ 08875-6800  
Tel: 732.563.3000  
L 1250 - HPM, L 1261 - HPA  
 
Page 4 of 5  
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE (Cont'd)  
Safe Handling: Read and Follow the installation/operating instructions listed below to help  
reduce risk of personal injury and property damage and help prevent early lamp failure:  
1) Before lamp installation/replacement, shut power off & allow lamp & fixture to cool to  
avoid  
electrical shock & potential burn hazards.  
2) Protect lamp from abrasions & scratches. Do not install or use cracked or broken lamp. If  
lamp cracks or breaks in use, disconnect power supply immediately, allow system to cool &  
remove lamp.  
3) Do not touch lamp with bare hands. If touched with hands, clean lamp with denatured  
alcohol and wipe with a lint-free cloth before installing.  
4) Replace lamp at or before the end of rated life. Allowing lamp to operate until it fails is not  
recommended and may increase the risk of inner arc tube rupture.  
5) Use within voltage limits recommended by ballast manufacturer. Do not operate lamp at  
higher than specified power.  
6) The permissible maximum operating temperatures (e.g., the pinch temperatures, the  
tempera-  
ture of the bulb wall) as indicated on the product leaflet may not be exceeded.  
7) Lamp should be operated within 10 degrees of the horizontal position to insure maximum  
operating efficiency.  
SECTION 8: SPECIAL PROTECTION DATA  
WARNING: THIS LAMP EMITS SHORTWAVE ULTRAVIOLET RADIATION. USE  
ONLY IN EQUIPMENT DESIGNED TO REDUCE RISK OF PERSONAL INJURY AND  
PROPERTY DAMAGE.  
DO NOT LOOK AT OPERATING LAMP WITHOUT  
PROTECTIVE FIXTURE AND/OR PROTECTIVE GOGGLES. DO NOT USE LAMP IF  
ULTRAVIOLET FILTER GLASS IS MISSING OR DAMAGED.  
A division of  
Philips Electronics North America Corporation  
200 Franklin Square Drive  
P.O. Box 6800  
Somerset, NJ 08875-6800  
Tel: 732.563.3000  
 
L 1250 - HPM, L 1261 - HPA  
Page 5 of 5  
SECTION 9: SPECIAL PRECAUTIONS & COMMENTS  
No restrictions as product shipped by truck, air or water. Spent lamps may require D008 RCRA  
classification. If state adopts universal waste rule, spent lamps can be shipped using common  
carrier and bills-of-lading. Contact your state environmental agency for guidance.  
Prepared: 8/9/95  
S21-95001  
A division of  
Philips Electronics North America Corporation  
200 Franklin Square Drive  
P.O. Box 6800  
Somerset, NJ 08875-6800  
Tel: 732.563.3000  
 

Pelco Security Camera C342M PSA 11 98 User Manual
Pelco Security Camera C2444M C User Manual
Philips Computer Monitor 107E50 User Manual
Philips CRT Television 14PT1356 05 User Manual
Philips Electric Shaver 4402LC User Manual
Philips Headphones HC 070 User Manual
Philips Home Theater System HTS3548W User Manual
Philips Switch SWV3570 User Manual
Philips Work Light SBCFL141 01B User Manual
Poulan Snow Blower 428558 User Manual