Pelco DVR DX4500 4600 User Manual

USING NO-IP.COM FOR DX4500/4600  
WEB ADDRESS  
April 10, 2008  
Tech Tips  
Helpful Tips for Pelco Products  
USING NO-IP.COM FOR DDNS ON THE DX45_46 WEB ADDRESS  
To change the IP address to a domain name as described in the operation/configuration manual on  
page 56, follow the instructions below. If the DVR is installed in a network that has a firewall, port 8245  
has to be opened to allow DDNS data to get through the firewall. For information about setting up the  
firewall, refer to your network administrator or network service provider.  
1. Go to www.no-ip.com and create an account.  
2. Under the Hosts / Redirects panel, select Add.  
World Headquarters  
Pelco and the Pelco logo are registered trademarks of Pelco, Inc.  
Information subject to change without notice.  
3500 Pelco Way, Clovis, California 93612 USA  
USA & Canada Tel: 800/289-9100 Fax: 800/289-9150  
International Tel:1-559/292-1981 Fax:1-559/348-1120  
©Copyright 2008, Pelco, Inc. All rights reserved.  
Page 1 of 2  
DX4500_4600_NO-IP.COM.fm  
 

Pelco Boiler MPTV1510 User Manual
Pelco Security Camera MRU User Manual
Philips Car Stereo System 21PT9457 User Manual
Philips Flat Panel Television HQ40 User Manual
Philips Headphones SWS4000 00 User Manual
Philips Speaker SBC BP015 User Manual
Philips Universal Remote MG301S User Manual
Porter Cable Air Compressor 1000003754 User Manual
Powermate Portable Generator PC0525304 User Manual
PSB Speakers Speaker CW260 User Manual