38i
Unidirectional
Dynamic
Element Type:
Hum Compensation Coil)
Polar Pattern:
Impedance:
Low (300 ohms
Frequency Response:
50 to 16,000 Hz
Sensitivity:
Output Power Level
-56
(0
1
Open Circuit Voltage
-75.5 (0
1
Hum Induction:
Equivalent to 9.0
SPL
(Hum output of microphone
a
hum field is equal to its output
SPL acoustic source)
from a 9.0
Case (Housing):
Black solid metal
Windscreen:
Brazed steel mesh with dual Integral foam
pop filters
Connector:
XLR
Weight:
7 oz. (198.5 grams)
between low frequencies and the mid-
presence rise in a
clean, natural sound that can become
as sultry or forceful as the performer
desires.
l
Dual stage pop filtering
Furnished Accessories:
Swivel adaptor, foam windscreen, and soft
carrying pouch
* Robust construction
l
External windscreen, stand adaptor
and soft carrying pouch supplied
1
10 dynes/cm*
DESCRIPTION
The
381
IS
a unidirectional
FEATURES
with features and
l
l
l
l
Clean, well balanced sound
Very low handling and stand
off-axis rejection
performance optimized for hand-held
vocal excellence.
The frequency response IS carefully
tailored to provide a proper balance
coil to reject induced
electrical
The microphone shall have a
reflecting black finish on a solid metal
case and a brazed metal screen. The
The compact, handsome PVM 38i of-
fers all that is needed for top vocal per-
formance in any venue.
The
shock
38i also features a refined
which provides a
very low sensitivity to annoying handling
and stand noises.
connector shall be a
XLR
equivalent audio type and a swivel
adaptor shall be provided to mount on
ARCHITECTURAL
Feedback and coloration from nearby
monitors or the house system are effec-
tively controlled by the very uniform
dioid directional properties.
ENGINEERING
a stand having
27 thread. The
SPECIFICATIONS
microphone shall have overall dimen-
The microphone shall be a moving
dynamic type with a frequency
response of 50 Hz to 16,000 Hz. The
microphone shall have a cardioid polar
characteristic with a rear response that
sions of
in length and
in
And the PVM 38i is rugged! With a
tough metal handle and brazed steel
wire outer grille, this microphone comes
ready for the road.
diameter. The
Peavey model
shall be a
38i or equivalent.
is about 20
down. The
shall have an output power level of
-56.0
per
pedance
where 0
1
and nominal im-
of 300 ohms.
DIMENSIONS
INCHES
(MILLIMETERS)
2
WIRING DIAGRAM
HUM COMPENSATION COIL
RED
I
I
I
I
BLUE
146
I
I
I
(INWARD) PRESSURE ON DIAPHRAGM
PRODUCES POSITIVE VOLTAGE AT
I
I
- - - - - - - -
5
per division
180”
Frequency Response
Proximity Effect
20
20
1
5
10
50 Hz
HZ
200 Hz
500 Hz
1
10
50 Hz
100 Hz
200 Hz
500 Hz
Frequency Response
ABOVE LIMITATIONS OR EXCLUSIONS MAY
NOT APPLY TO YOU. THIS LIMITED
WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS, AND YOU MAY ALSO HAVE OTHER
RIGHTS WHICH MAY VARY FROM STATE TO
STATE.
PEAVEY ELECTRONICS CORPORATION
(“Peavey”) warrants this microphone to the
original retail purchaser to be free from defects
in material and workmanship for a period of
one (1) year from date of purchase; provided,
however, that the existence of this limited
warranty is subject to the conditions,
warranty and the other terms and conditions
expressed herein have been complied with,
Peavey will provide the necessary warranty
service to repair or replace the
and will return it, freight collect, to the
consumer.
In the event any modification or disclaimer
of express or implied warranties or any
limitation of remedies contained herein
conflicts with applicable law, then such
modification, disclaimer or limitation as the
case may be, shall be deemed to be modified
to the extent necessary to comply with such
law.
Under no circumstances will Peavey be
liable for any lost profits, lost savings or other
consequential or incidental damages arising
out of the use or inability to use the product,
even if Peavey had been advised of the
possibility of such damages.
exclusions and limitations hereinafter set forth.
In case of a covered defect in material or
workmanship, Peavey will repair or replace the
microphone, at Peavey’s option, provided that
consumer:
THIS LIMITED WARRANTY IS IN LIEU OF
ANY AND ALL WARRANTIES, EXPRESSED
OR IMPLIED, INCLUDING, BUT NOT
LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR
PARTICULAR USE; provided, however, that
upon compliance with the other terms and
conditions necessary to the existence of the
express limited warranty, such implied
warranties are not disclaimed during the
applicable one year period from date of
purchase of this product.
(a) brings the defective microphone to any
Peavey Authorized Dealer or Service Center
and presents therewith a copy of the sales
receipt or other proof of purchase. If the
DEALER or SERVICE CENTER is unable to
provide the necessary warranty service, the
consumer will be directed to the nearest other
PEAVEY AUTHORIZED DEALER or SERVICE
CENTER which can provide such service; or
Peavey Electronics Corporation gives this
limited warranty only with respect to Peavey
microphones purchased in the United States of
America. This limited warranty shall be void
and of no effect if:
(a) first purchase of the product is for the
purpose of resale; or
(b) the original retail purchase is not made
from an AUTHORIZED PEAVEY DEALER; or
(c) the product has been damaged by
accident or unreasonable use, neglect,
improper service or maintenance, or other
causes not arising out of defects in material or
workmanship.
(b) returns the defective microphone,
shipping charges prepaid, to Peavey
Electronics Corporation, 711 A Street,
Meridian, Mississippi, and includes therewith a
written description of the problem, a copy of
the sales receipt or other proof of purchase
and consumer’s complete return address.
SOME STATES DO NOT ALLOW
LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS OR THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE
If the defect is remedial under this limited
Features and specifications subject to change without notice.
Peavey Electronics Corporation 711 A Street Meridian, MS 39302-2898 U.S.A.
/Telex 504115 Fax 486-l 278
Printed in U.S.A.
01993
|