S P E C
F I L E
Dual Stacking Mount Bracket
Description
ET-DFD75
This mount bracket is to be used when stacking two DLP™-based projectors.
Specifications
Dimensions (W x H x D):
Weight:
650 x 589 x 680 mm (25-9/16˝ x 23-3/16˝ x 26-3/4˝)
27 kg (59.5 lbs)
Weights and dimensions shown are approximate. Specifications subject to change without notice.
Digital Light Processing and DLP are trademarks of Texas Instruments.
Parts
Base frame . . . . . . . . . . . . . . . . . . . . .1
Guard frame . . . . . . . . . . . . . . . . . . . .2
Spring washers (M8) . . . . . . . . . . . . . .8
Allen hex socket bolts (M8) . . . . . . . . .4
Mounting nuts A (M8) . . . . . . . . . . . . . .4
Adjustment bolts (M8) . . . . . . . . . . . . .4
Flat washers A . . . . . . . . . . . . . . . . . .4
Flat washers B . . . . . . . . . . . . . . . . . .4
Mounting nuts B (M8) . . . . . . . . . . . . . .4
Flat washers (M4) . . . . . . . . . . . . . . . .4
Spring washers (M4) . . . . . . . . . . . . . .4
Hex nuts (M4) . . . . . . . . . . . . . . . . . . .4
Cable guide fitting . . . . . . . . . . . . . . . .2
Washer-fitted screws (M4 x 8) . . . . . .20
Spacers . . . . . . . . . . . . . . . . . . . . . . .10
Set mounting base A . . . . . . . . . . . . . .1
Set mounting base B . . . . . . . . . . . . . .1
Screws (M6) . . . . . . . . . . . . . . . . . . .10
Hex nuts (M8) . . . . . . . . . . . . . . . . . . .8
Flat washers (M8) . . . . . . . . . . . . . . . .8
Caution:
Mounting should be done by a qualified technician. Make sure that the mounting (ceiling) area has
sufficient strength. Read the enclosed mounting instructions thoroughly before starting.
Dimensions
650 (25.6˝)
The ET-DFD75 with two DLP™-based
projector mounted.
unit: mm (inch)
(Dimensions given in inches are approximate.)
Note: This illustration is not drawn to scale.
As of September 2004
1
|