Oreck Vacuum Cleaner BR225 User Manual

S I M P L Y  
A M A Z I N G ™  
USERS GUIDE  
BR225  
•IMPORTANT•  
SAVE THIS BOOKLET!  
Includes:  
• Safety Warnings  
• Warranty  
• Operating Instructions  
• Trouble Diagnosis  
• Accessories  
 
Operating Instructions  
To Replace Filter Bag  
WARNING: Unplug cord from electrical  
outlet before servicing.  
Plug cord into electrical outlet.  
Power Switch  
ELECTRIKBROOM  
To ensure that your ORECK ELECTRIKBROOM Powerbrush  
cleaner provides you with optimal performance, use only ORECK  
brand bags. Replace the filter bag more frequently when picking  
up fine materials such as powders, plaster dust, ashes and soot.  
These materials may seal the filter bag before it appears full.  
POWER SWITCH  
Push power switch to  
“ON” (l) position.  
STEP 1: Remove Filter Bag Assembly  
Remove the filter bag assembly by:  
1) Grasping its top and  
2
pushing down.  
2) Pulling top of filter bag  
assembly out and away  
from the cleaner.  
Swivel Nozzle  
The swivel nozzle feature  
allows you to clean under  
furniture easily. Simply twist  
cleaner to side until the unit  
lies flat and parallel to the  
floor. Then guide the nozzle  
into hard to reach places.  
1
Cord Restraint  
A cord restraint clip is  
STEP 2: Remove Used Filter Bag  
conveniently molded into the  
handle to lift cord out of  
your way while vacuuming.  
Remove used filter bag by  
grasping the cardboard  
collar and pulling it past the  
raised locking tabs on the  
dirt tube. Discard used bag.  
CORD RESTRAINT  
Telescopic Handle  
COLLAR LOCK  
To adjust the handle height,  
simply grasp handle grip  
and rotate collar lock at  
lower end of handle  
counter-clockwise to loosen.  
Then slide handle up or  
down to desired height.  
Gently tighten collar lock  
down clockwise onto threads  
to lock handle into place.  
STEP 3: Install New Filter Bag  
Install new filter bag by pushing cardboard collar past locking  
tabs on the dirt tube. Make sure the filter bag is fully extended  
and tucked into the filter bag assembly.  
STEP 4: Replace Filter Bag Assembly  
Replace bottom of the filter bag assembly into the side of the  
cleaner. While pressing down, pivot top of filter bag assembly  
in until to catch snaps into place.  
To Store the Cleaner  
IMPORTANT: Do not operate cleaner  
without filter bag in place.  
Wrap the power cord around rear of unit. For compact storage,  
retract telescoping handle down. Hang cleaner on a hook from  
the opening located at the top of the handle.  
Damage to the motor will occur.  
The convenient ORECK ELECTRIKBROOM vacuum cleaner is  
always at your fingertips for quick clean-ups anywhere.  
To order:  
Replacement Filter Bags  
Part No. OR162  
NOTE: These cleaners do not stand upright  
alone. Make sure the cleaner is properly  
supported when not in use or unattended.  
Call your authorized ORECK Service Center, your authorized  
ORECK dealer, or the Service Center Hotline:  
toll free at US: 1-800-989-3535  
Canada: 1-800-393-8801  
3
 
Troubleshooting Guide  
Warranty  
WARNING: Unplug cord from  
electrical outlet before servicing.  
ORECK MANUFACTURING COMPANY: (ORECK gives  
you the following limited warranty for this product only if it  
was originally purchased for use, not resale, from ORECK  
or an ORECK Authorized Retail Dealer.)  
SAVE SERVICE CALLS...CHECK THESE FIRST:  
• Is the disposable filter dust bag full?  
ORECK will repair or replace, free of charge, to the  
original purchaser, any part which is found to be defective  
in material or workmanship within two (2) years of the  
date of purchase. This limited warranty applies to normal  
domestic use. Any commercial use of this product will  
void this limited warranty.  
• Are pores of filter dust bag clogged with powder or fine dust?  
• Is anything clogging the revolving brush, intake opening?  
• Is the belt in place and turning the brush?  
• Does the brush turn freely? Are hair, string or rug fibers wound  
around the brush?  
PROBLEM  
CLEANER  
POSSIBLE SOURCE  
AREAS TO CHECK  
Drive belts, revolving brushes, bulbs, disposable bags,  
and other parts subject to normal wear are not covered by  
this limited warranty.  
Not plugged in  
properly.  
Be sure cleaner is  
firmly plugged  
WILL NOT RUN  
into wall outlet.  
This limited warranty does not apply to any part subjected  
to accident, abuse, commercial use, alteration, misuse,  
damage caused by fire or act of God, the use of voltages  
other than indicated on the serial number plate of this  
product or service of this product by other than ORECK or  
an ORECK Factory Authorized Service Center.  
No electricity in  
wall outlet.  
Check electrical  
source–fuse or  
circuit breaker.  
CLEANER  
SUCTION LOW  
Filter bag is full.  
Replace filter bag.  
See “To Install  
Paper Filter Dust  
Bag.”  
ORECK does not authorize any person or representative to  
assume or grant any other warranty obligation with the  
sale of this product.  
Nozzle is clogged. Clear obstruction.  
FILTER BAG ASSEMBLY  
DIFFICULT TO INSTALL  
AND REMOVE  
Debris in bottom  
of filter bag  
Clean seal area at  
bottom of filter bag  
ORECK’S limited warranty is valid only if you retain proof  
of purchase from ORECK or an ORECK Authorized Retail  
Dealer for this product. If you purchase this product from  
any other source, your purchase is “AS IS,” which means  
ORECK grants you no warranty, and that you, not ORECK,  
assume the entire risk of the quality and performance of  
this product, including the entire cost of any necessary  
servicing or repairs of any defects.  
housing opening. housing opening.  
Filter bag not in  
place.  
Install filter bag  
properly.  
CLEANER NOZZLE  
WILL NOT SWIVEL  
Swivel ring posts  
not in correct  
position.  
Remove swivel  
clamp screws from  
bottom of nozzle  
carefully.  
or  
Reassemble nozzle  
to unit, making  
certain swivel ring  
posts are seated  
correctly.  
ORECK’S liability for damages to you for any costs  
whatsoever arising out of this statement of limited warranty  
shall be limited to the amount paid for this product at the  
time of original purchase, and ORECK shall not be liable  
for any direct, indirect, consequential or incidental  
damages arising out of the use or inability to use this  
product.  
Debris around  
swivel ring.  
HANDLE WILL NOT  
STAY IN POSITION  
Handle collar lock Firmly tighten  
not tightened  
securely.  
handle collar lock  
in clockwise  
direction.  
Some states do not allow the exclusion or limitation of  
incidental or consequential damages, so the above  
limitation or exclusion may not apply to you.  
ALL OTHER SERVICING SHOULD BE DONE BY AN  
ORECK AUTHORIZED SERVICE CENTER.  
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS  
PRODUCT, INCLUDING IMPLIED WARRANTIES OF  
MERCHANTABILITY AND FITNESS FOR A PARTICULAR  
PURPOSE, ARE LIMITED IN DURATION TO THE  
CALL CUSTOMER SERVICE HOT LINE  
US: 1-800-989-3535  
Canada: 1-800-393-8801  
WARRANTY PERIOD, AND NO WARRANTIES, WHETHER  
EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.  
Whenever calling, please be sure to have your model and  
serial number from data plate.  
Some states do not allow limitations on the duration of  
implied warranties, so the above limitation may not apply  
to you.  
This warranty gives you specific legal rights, and you may  
also have other rights which vary from state to state.  
© 2001 Oreck Holdings, LLC. All Rights Reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC.  
Printed in America  
26869-03 REV B  
6/01 ECN# R-6039  
 

Miele Ventilation Hood 09 885 260 User Manual
Miller Electric Welding System OM 4409 User Manual
MTD Tiller 12211 User Manual
Murphy Switch Annunciators and Magnetic Switches User Manual
Nextar Speaker NXBT 001 User Manual
Nielsen Kellerman Watch 2000xc User Manual
Optoma Technology Projector EP615H User Manual
Panasonic Beverage Dispenser ED250 BCP User Manual
Panasonic Drill EY7440 User Manual
Panasonic Garage Door Opener CZ RD516C 1 User Manual