Pairing Mode – Optoma 3D-RF System: Optoma 3D-RF Glasses and Optoma 3D-RF
Emitter for Optoma 3D-XL Converter Box and 3D ready projector models HD83, HD33,
GT750.
Contains Patent Pending software and technology from Bit Cauldron
Contient les logitiels de brevet en instance et la technologie de la compagnie Bit Cauldron
Connections
Optoma 3D-XL converter box with 3D Emitter Port
Connect the Optoma 3D-RF emitter to the Optoma 3D-XL converter box using the IR Emitter Port as shown below.
LED Indicators
After cable connection the LEDs will display a red moving pattern while the emitter is attempting to acquire a 3D signal and until a
3D sync signal is found. The joystick of Optoma 3D-RF Emitter can be moved in any direction to enable pairing mode. If any
Green LEDs are on, push the joystick in any direction for a second until all LEDs are off. Then push the joystick in any direction for
3 seconds until 3 green LEDs turn ON. Release the joystick when 3 green LEDs turn ON. You can always remove the cable and
start over if you end up in wrong move.
Copyright 2011 Bit Cauldron Corporation
Page 1 of 2
|