NS-IW560C
HOME CINEMA IN-CEILING SPEAKER
CONTENTS
CONSUMER PRECAUTIONS ........................................................................... 2
UNPACKING ...................................................................................................... 3
TOOLS NEEDED ............................................................................................... 3
SPEAKER PLACEMENT ....................................................................................3
INSTALLATION ..................................................................................................4
CONNECTIONS .................................................................................................6
PAINTING THE SPEAKER FRAME AND GRILL ...............................................7
SPECIFICATIONS ..............................................................................................7
WARRANTY ....................................................................................... Back cover
OWNER’S MANUAL
UNPACKING
After unpacking, check that the following items are contained.
10-9/32”
9-7/16”
4-3/32”
TEMPLATE
NS-IW560C
Speaker System x2
Cutout
template x1
Speaker
Grill x2
Paint Protective
Cover x2
Glue Strips x2
TOOLS NEEDED
Drill
Wire strippers
Gloves
Drywall saw
Pencil
Safety goggles
Sturdy wire
(such as a coat hanger)
Philips screwdriver
SPEAKER PLACEMENT
These speakers are not magnetically shielded. Avoid installing the speakers too close to your TV.
• Home Theater
• Stereo
Use these speakers for left and right surround
channels. Surround speakers should ideally be placed
behind the listening area, at least as far apart as the
front speakers and up to 2 additional feet apart per
side.
For best stereo performance, install the left and right
speakers at equal distance from the listening position.
Each speaker should be separated by a distance of 6-
10 ft.
3
INSTALLATION
Before installation, check to ensure that the area you are installing the speaker is free of any ceiling joints, by
tapping the ceiling or using a stud finder.
If you wish to paint the speaker frame and grill, please refer to page 7 “PAINTING THE SPEAKER FRAME AND
GRILL” before proceeding.
1
2
3
Position the cutout template where you are
installing the speaker. Then trace around the
template with a pencil.
4
Cut the ceiling along the outline you traced.
TEMPLATE
5
Run high quality speaker cable from your
receiver to your speakers. Leave a few extra feet
of cable.
Drill a pilot hole in the center outline you traced.
Note:
You can insulate the cavity by placing a sheet of
fiberglass insulation around the speaker
components to improve speaker performance.
Insert the bent coat hanger wire into the hole.
Then slowly rotate to check for any obstruction. If
there is any obstruction, patch the hole and
select another location.
360°
4
6
Connect the speaker cable to the speaker and
your receiver. Please refer to page 6,
“CONNECTIONS” section for detailed
instructions.
9
Attach the grill to the frame.
Glue strips
7
Place the speaker into the ceiling.
Note:
For secure grill attachment, application of the
supplied glue strips is recommended.
Recommended Glue Strip Location
8
Tighten each of the four screws evenly until the
clamps at the back of the frame grip the ceiling
to secure the speaker.
Note:
You can swivel the tweeter to direct high
frequency sounds precisely toward the listening
position by gently pressing the outer edge of the
tweeter mount.
5
CONNECTIONS
• Connect the push-type input terminals at the rear of the speakers to the speaker output terminals of the
receiver.
• Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect
the (−) terminals on both components using the other side of the cable.
NS-IW560C
Receiver
+ −
−
+
Notes:
• Make sure that the bare wires are not touching each other as this could damage the speaker and receiver.
• Connect one speaker to the left terminals of your receiver, and another speaker to the right terminals,
making sure no to reverse the polarity (+, −). If one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
How to connect
When using a banana plug
•
•
1 Press and hold down the speaker terminal.
2 Insert the bare wire. Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.
1 Insert the banana plug into the top of the
terminal as shown below:
3 Release the terminal. Test the firmness of the
connection by pulling lightly on the cable at the
terminal.
Banana plug
1
1
Black (−)
Red (+)
2
(−)
(+)
6
PAINTING THE SPEAKER FRAME AND GRILL
The speaker frame and grill can be painted to match your room décor. Use high quality spray paint and select a
well ventilated area before proceeding.
Painting the frame
Painting the grill
•
•
1 Remove the speaker from the ceiling if it is already
installed. Also, remove the grill from the baffle.
2 Mask the speaker components and the baffle with
the supplied paint protective cover.
1 Carefully remove the grill from the speaker, if
attached.
2 Apply the paint to the grill. Make sure that the grill
holes remain free of paint. Clogging the holes with
paint may diminish the sound quality.
3 Apply the paint to the frame.
Paint protective
cover
Speaker Grill
SPECIFICATIONS
Speaker
8” woofer Kevlar cone x 1 , 1” Titanium dome tweeter
Frequency Range
Impedance
45 Hz - 28 KHz
8 ohms
Nominal lnput
50 W
Maximum lnput
Sensitivity (dB/2.83v. 1m)
Crossover Frequency
Dimension (Diameter x Depth)
(Mounting depth)
Weight
150 W
88 dB
6,000 Hz
10-9/32” x 4-13/32” (with grille) (261 x 111.6 mm)
3-23/32” (94.3 mm)
4.5 lbs (2.05Kg)
No
Magnetic Shielding
*Specifications subject to change without notioe due to product improvements.
7
YAMAHA Electronics Corporation, USA, is proud of the experienced craftsmanship that goes into each and every YAMAHA Loudspeaker. YAMAHA sells
its products only through a network of high quality, specially authorized dealers and is pleased to offer the following Limited Warranty, which applies only
to products purchased by consumers directly from our authorized dealers. We suggest that you read the Limited Warranty thoroughly, and invite you to
contact your authorized YAMAHA dealer or the YAMAHA Electronics Corporation, USA, Service Department if you have any questions.
SPEAKER SYSTEMS LIMITED WARRANTY
Duration of Warranty:
Yamaha Loudspeakers are covered by this warranty for a period of 2 years from date of purchase.
What is Covered and what is Not Covered:
This warranty covers all defects in materials or workmanship, but DOES NOT COVER the following:
(1) Damage, deterioration or malfunction resulting from:
a. Accident, negligence, misuse, abuse, improper installation or operation or failure to follow instructions contained in your Owner’s Manual.
b. Any shipment of the product. (Claims must be presented to the carrier.)
c. Repair or attempted repair by anyone other than YAMAHA or a specially authorized YAMAHA Service Center.
(2) Any unit which has been altered, or on which the serial number or cabinet has been defaced, modified or removed.
(3) Consequential, economic or property damage.
(4) Normal wear and maintenance.
(5) Initial setup or check-ups with ho defects found.
(6) Labor & materials required to remove and reinstall the loudspeaker.
(7) Any unit which has not been purchased by the consumer directly from an authorized YAMAHA dealer in the USA or Puerto Rico. If you are
uncertain as to whether a dealer has been authorized by YAMAHA, please contact YAMAHA at the telephone number shown below.
(8) Any unit used for industrial or commercial purposes.
Who may enforce the warranty:
This warranty is enforceable only by the original purchaser of the unit, who purchased from a Yamaha dealer authorized to make that sale.
What we will pay for and what you must pay for”
YAMAHA will repair or replace products covered by this warranty, without charge to the consumer for labor or materials. Some repair parts may be
used or rebuilt replacements, that meet or exceed Yamaha specifications for new parts, in exchange for defective parts. YOU ARE RESPONSIBLE
FOR ANY INSTALLATION OR REMOVAL CHARGES AND FOR ANY INITIAL SHIPPING CHARGES, if the product(s) must be shipped for
warranty service. However, we will pay the return shipping charges to any destination within the USA if the repairs are covered by the warranty.
How you can get Warranty Service:
(1) If your YAMAHA loudspeaker(s) appears to require service, contact the authorized YAMAHA dealer and the dealer will advise you of the
procedures to be followed. If this is not practical, deliver the defective product(s) to a specially authorized YAMAHA Service Center (obtain
referrals from the YAMAHA Web site or toll-free YAMAHA phone number shown below).
(2) Product(s) shipped for service should be packed securely and must be accompanied by a detailed explanation of the problem(s) requiring
service, as well as your sales receipt or other proof of date and place of purchase, as evidence of warranty coverage.
(3) Warranty registration is not required for warranty coverage.
Limitation of Implied Warranties:
ANY IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE LENGTH OF THIS EXPRESS WARRANTY. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG
AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
Exclusion of Damages:
YAMAHA’S LIABILITY FOR ANY DEFECTIVE PRODUCT IS LIMITED TO REPAIR OR REPLACEMENT OF THE PRODUCT, AT OUR OPTION.
IF WE ELECT TO REPLACE THE PRODUCT, THE REPLACEMENT MAY BE A RECONDITIONED UNIT. YAMAHA SHALL NOT BE LIABLE FOR
DAMAGES BASED UPON INCONVENIENCE, LOSS OF USE, DAMAGE TO ANY OTHER EQUIPMENT OR OTHER ITEMS AT THE SITE OF
USE, OR ANY OTHER DAMAGES WHETHER INCIDENTAL, CONSEQUENTIAL OR OTHERWISE. SOME STATES DO NOT ALLOW
LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES
YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
Should you have any questions about service received or if you need assistance in locating an authorized YAMAHA Service Center, please
contact:
SERVICE DEPARTMENT
YAMAHA Electronics Corporation, USA
6660 Orangethorpe Avenue, Buena Park,California 90620-1345
internet URL: www.yamaha.com/yec
For referral to your nearest authorized YAMAHA Preferred Customer Service Center call 1-800-4YAMAHA.
Do not return any product to the above address without a written Return Authorization issued by YAMAHA.
P/N 430051
Printed in China
|