New Holland
Pull-Type Forage Harvester Specifications
790 FP230 FP240
MODEL
790
FP230
FP240
Weight (single axle), lbs. (kg)
Length, ft. in. (m)
3104 (1411)
16’ 1-1⁄4” (4.98)
10’ 6” (3.2)
9’ 6” (2.79)
4500 (2040)
4700 (2130)
................................................................21’ 6” (6.5) ................................................................
.....................................................................11’ 2”.....................................................................
................................................................10’ 8” (3.3) ................................................................
Height with standard spout, ft. in. (m)
Width, ft. in. (m)
Number/type of knives..........................................................................................................12 single-edge hardened alloy ......................................................................................
Cutterhead, type/speed ..................................................................................................................Cylinder, 850 rpm ..............................................................................................
Cutterhead, diameter, in. (mm)
Throat opening, in. (mm)
19-5⁄16 (490.5)
19 x 4-5⁄8 (482 x 117)
.................................................................21 (533.4).................................................................
22 x 6-5⁄8 (558.8 x 167.7) 24-3⁄8 x 6-5⁄8 (619.76 x 167.6)
Shearbar ..............................................................................................Quick adjust, reversible, hard-faced on vertical and horizontal surfaces......................................................
Length of cut, in. (mm)*
Blower speed
Recommended max. tractor hp
Minimum power required
Knife sharpener
Recutter screens (non processor units)
Vertical wheel adjustment, in. (mm)
Tire sizes, single axle
1⁄8 to 1-1⁄2 (3.2 to 38.1)
1000 or 750 rpm
150 PTO hp
....................................................3⁄16 to 7⁄16* (4.8 to 11.1) ....................................................
..................................................................1000 rpm..................................................................
225 PTO hp
150 PTO hp
300 hp
180 PTO hp
75 PTO hp
2” manual, built-in
5 sizes available
4-1⁄2 (114)
...........................................................3” manual, built-in...........................................................
.............................................................6 sizes available.............................................................
....................................................................6 (152)....................................................................
11Lx14 6PR standard
31x13.5-156PR optional
N/A
31x13.5-158PR standard
14Lx16.1 8PR optional
11Lx15-156PR
14Lx16.1 8PR standard
Tire sizes, tandem axle
11Lx15-15 6PR
*Longer lengths of cut can be obtained by removing knives—up to 1-5⁄16” length of cut with only four knives.
Optional CropPro™ Crop Processor
Construction
Not available
...................................................................Optional...................................................................
...............................................Hardened ductile iron, steel shaft...............................................
—
—
—
—
—
—
Weight, lbs. (kg)
490 (218)
520 (231)
Roll width, in. (mm)
Roll diameter, in. (mm)
Roll gap, in. (mm)
Roll speed
24-1/2 (622.3)
26-7⁄8 (682.6)
.................................................................7-7⁄8 (200).................................................................
......................................................3⁄16 to 5⁄8 (4.8 to 15.9) ......................................................
............................................................2650 rpm upper ............................................................
.............................................................2250 rpm lower.............................................................
Page 1of 2
|