Multi Link Garage Door Opener CB 390M User Manual

MultiLink®  
MINI GARAGE DOOR REMOTE  
WITH FLASH LIGHT  
MODEL : CB-390M  
1. PROGRAMMING YOUR NEW TRANSMITTER FOR  
6. FCC  
CHAMBERLAIN® / LIFTMASTER® / SEARS® OPENERS  
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference, and (2) This device must accept any interference  
received, including interference that may cause undesired operation.  
Thank you for your purchase of the MultiLink® garage door remote  
control, Model CB-390M. Please follow the details instructions below in  
order to setup the new transmitter to work with your existing opener.  
WARNING:  
Changes or modifications to this unit not expressly approved by the party responsible for compliance could  
void the user’s authority to operate the equipment.  
NOTE:  
You should find a “learn” button from your existing garage door opener  
(the unit with the motor located on the ceiling of your garage). Press and  
hold this “Learn” button for 2 seconds and then release. The LED light  
located beside the ‘Learn’ button will go on. Then press the garage door  
button on your new transmitter for 1 second and then release to activate  
it. The LED light on your existing  
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant  
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses and can radiate radio frequency  
energy and, if not installed and used in accordance with the instructions, may cause harmful interference  
to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does  
causeharmful interference to radio or television reception, which can be determined by turning the equipment  
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
Garage Door  
Opener (GDO)  
garage door opener will flash then  
go off. The model CB-390M is now  
- Reorient or relocate the receiving antenna.  
- Increase the separation between the equipment and receiver.  
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
programmed to your existing garage  
door opener and will operate your  
- Consult the dealer or an experienced radio/TV technician for help.  
garage door.  
‘Learn’ Button  
7. WARRANTY  
2. TROUBLESHOOTING  
If, within one year from date of purchase, this product should become defective  
(except battery), due to faulty workmanship or materials, it will be repaired or  
replaced, without charge. Proof of purchase and a Return Authorization are required.  
If the garage door cannot be activated, check the followings:  
- The red light LED should come on when the button is pressed, if not,  
check the battery and its polarity, ensure it is inserted properly.  
- Repeat programming again to ensure the new transmitter is programmed.  
8. CUSTOMER SERVICE  
Skylink will not be held liable or responsible for any misuse or application of this  
product other than for its intended use.  
3. OPERATION  
If you would like to order Skylink’s products or have difficulty getting them to  
work, please :  
Press and hold the plastic case  
where it marks “PRESS” to  
®
If you would like to order Skylink’s products or have difficulty getting them to work,  
please :  
2. email us at [email protected]m, or  
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.  
Fax 1-800-286-1320  
activate the flash light.  
Garage Door  
Button  
Press the garage door opener  
button will activate your garage  
door.  
4. BATTERY  
Positive "+"  
Up  
One 3 volt Lithium type (CR2032)  
battery is included.  
Replacing the battery.  
1. Open the case with a corn.  
2. Slide the old battery away from the battery holder.  
3. Slide in the new battery with the positive (+) side facing up.  
4. Firmly close the case.  
5. WARNING  
If this transmitter triggers other garage doors in your neighborhood,  
change all your transmitters and receiver to a new code setting.  
CUSTOMER SERVICE  
DO NOT let children use the garage door  
transmitter without adult supervision.  
Children can injure themselves or others  
by the garage door.  
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3  
P/N 101A374-001  
© 2005 SKYLINK GROUP  
® are registered trademarks of their respective corporations  
 

Multiquip Portable Generator DCA 56SPX User Manual
Multi Tech Systems Network Card MVP210 SS User Manual
Napco Security Technologies Home Security System F 64TPBR User Manual
NordicTrack Home Gym NTEL42552 User Manual
Nortel Networks Switch 24R9744 User Manual
NuTone Ventilation Hood 770F User Manual
Omron Healthcare Recording Equipment HJA 301 User Manual
Optimus Speaker 12 Dec User Manual
Orion Car Audio Car Amplifier HP 2800 User Manual
Panasonic DVD Player DVD S26 User Manual