W8LM
Mini Line Array
Mini, high performance three-way
line array enclosure
features
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Mini three-way line array element
Hybrid™ dual 8" (200mm) LF+MF configuration (-3dB@60Hz)
LF+MF - 100dB @1W, 1m (single cabinet)
Twin 1" (25mm) HF horn - 106dB @1W, 1m (single cabinet)
Consistent 100º (-6dB) horizontal mid and HF pattern control
Passive or biamp operation
12 ohm system impedance, up to 4 cabinets on one amplifier channel
Fast, integral rigging system with variable splay angles
ViewPoint™ array optimisation software
Factory controller presets for a wide variety of configurations
Compatible with W8L and W8LC line-array elements
Compatible with WSX, WLX and WMX subwoofers
applications
Q
Q
Q
Q
Q
Theatre Sound Reinforcement
Live Sound Reinforcement
Corporate Events
Fixed Installations
Delay systems for large scale outdoor sound reinforcement
The Martin Audio W8LM is a mini line array enclosure designed to bring line array performance benefits to a variety
of small and medium scale applications. It meets the need for a versatile, scalable system that can be flown or ground
stacked for corporate events, theatres and indoor venues. It is also suitable as a delay system for large scale outdoor
sound reinforcement.
Following the constant directivity horn design philosophy of the W8L and the W8LC, the W8LM is a three-way
system that combines line array principles with innovative horn loading techniques to produce a next generation,
small line array with maximum dynamic impact.
Amazingly for its size, the W8LM is a full-bandwidth system (-3dB @ 60Hz) and may be used without subwoofers
in many applications. Where additional low frequency extension is required, it is ideally complemented by ground
stacked WSX or WLX/WMX Hybrid™ folded horn/reflex loaded subs. Alternatively if flown sub-bass is required
then WLX/WMX Hybrid™ folded horn/reflex loaded subs may be used.
To achieve the vertical pattern required, practical line arrays are nearly always curved in the vertical plane –
invalidating some of the simplistic ideas about wavefront curvature associated with first generation line arrays. The
acoustic elements of the W8LM have been developed to have optimal wavefront curvature characteristics for real
world situations where higher degrees of array curvature are likely.
Whilst the W8LM is a three-way system, it can be driven two-way active or entirely passively via its internal
crossover, (selected by a rear mounted switch). To make system design even more cost effective, the W8LM is a 12
ohm cabinet and up to four cabinets can be driven off one channel of a professional quality amplifier such as the
MA2.8s or MA4.2s.
The minimum number of W8LM elements in an array is 3, but most applications will require blocks of 4, 8 or 12
elements, depending on the required output capability and
vertical coverage angle.
Century Point, Halifax Road, Cressex Business Park,
High Wycombe, Buckinghamshire HP12 3SL, England.
Telephone: +44 (0)1494 535312 Facsimile: +44 (0)1494 438669
E-mail: [email protected]
All information is Copyright © 2006 Martin Audio Ltd.
1 of 5
W8LM
Mini Line Array
Mini, high performance three-way
line array enclosure
frequency responses
Century Point, Halifax Road, Cressex Business Park,
High Wycombe, Buckinghamshire HP12 3SL, England.
Telephone: +44 (0)1494 535312 Facsimile: +44 (0)1494 438669
E-mail: [email protected]
All information is Copyright © 2006 Martin Audio Ltd.
3 of 5
W8LM
Mini Line Array
Mini, high performance three-way
line array enclosure
overall dimensions
Century Point, Halifax Road, Cressex Business Park,
High Wycombe, Buckinghamshire HP12 3SL, England.
Telephone: +44 (0)1494 535312 Facsimile: +44 (0)1494 438669
E-mail: [email protected]
All information is Copyright © 2006 Martin Audio Ltd.
4 of 5
W8LM
Mini Line Array
Mini, high performance three-way
line array enclosure
technical specifications (single enclosure)
architectural and engineering specifications
The loudspeaker system shall be of the three-way
horizontally formatted line array type, switchable
passive/bi-amp. The low and mid frequency sections shall
consist of two 8" (200mm) cone transducers, one direct
radiating and reflex loaded and one front loaded by a
constant directivity mid-horn using a toroidal phase plug
and reflex loaded, with both sharing the same enclosure.
The drivers shall operate in tandem to produce low
frequencies up to 300Hz. Above 300Hz, the direct
radiator driver shall be rolled off by an internal passive
network and the horn loaded driver reproduce mid
frequencies up to 2.2kHz. The high frequency section
shall consist of two 1" (25mm) horn elements vertically
mounted to produce a low-curvature vertical wavefront.
The enclosure shall be constructed of heavily braced
multi-laminate plywood with all flying hardware integral
and captive. Bi-amp or passive operation shall be selected
by a switch at the rear of the enclosure. In bi-amp mode
the loudspeaker shall be operated with a separate
electronic controller providing a 2.2kHz crossover
between mid and high frequencies. In passive mode the
mid and high frequency sections shall be integrated by an
internal 2.2kHz crossover network.
TYPE
Three-way, compact line array element
FREQUENCY RESPONSE (5) 60Hz-18kHz 3dB
DRIVERS: LF + MF Section
8" (200mm)/2" (50mm) voice coil, reflex-loaded
direct radiator
8" (200mm)/2" (50mm) voice coil, neodymium
driver, front horn loaded, rear reflex loaded
2 x 1" (25mm) exit HF compression drivers,
horn loaded
LF + MF: 400W AES, 1600W peak
HF: 75W AES, 300W peak
Passive: 400W AES, 1600W peak
LF + MF: 100dB
DRIVERS: HF Section
RATED POWER (2)
SENSITIVITY (6)
HF: 106dB
Passive: 99dB rising to 105dB at HF
MAXIMUM SPL (calculated @ 1m) LF + MF: 125dB continuous, 131dB peak
HF: 125dB continuous, 131dB peak
Passive: 124dB continuous, 130dB peak
LF + MF: 12 ohms
HF: 12 ohms
Passive: 12 ohms
100º horizontal (down to 800Hz),
7.5º vertical
120º horizontal (down to 700Hz) @ -10dB
300Hz passive, 2.2kHz active or passive
Vertical trapezoid with 3.75º wall angle, multi-
laminate birch ply construction
Textured paint
Perforated steel
2 x Neutrik NL4
(W) 620mm x (H) 243mm x (D) 400mm
(W) 24.4ins x (H) 9.6ins x (D) 15.8ins
29kg (64lbs)
NOMINAL IMPEDANCE
DISPERSION (-6dB)
CROSSOVER
ENCLOSURE
FINISH
PROTECTIVE GRILLE
CONNECTORS
DIMENSIONS
Performance of the loudspeaker system with its
electronic controller shall meet or exceed the following
criteria:
Frequency response measured 1 metre on axis shall be
60Hz-18kHz 3dB.
High frequency dispersion at -6dB points shall be
100˚H x 7.5˚V.
Power handling shall be 400W AES, 1600W peak FR/(LF
+ MF), 75W AES, 300W peak HF.
Rated impedance shall be 12 ohms FR/(MF + HF),
12ohms HF.
WEIGHT (including rigging hardware)
accessories
ASF20001
ASF20002
HAM09002
HTK175
Flying frame
Lifting bar
Groundstack bar
Flying pin
N o t e s
(1) Measured on-axis in half space at 2 metres, then referred to 1 metre.
(2) AES Standard ANSI S4.26-1984.
(3) Measured in half space at 2 metres with 1 watt input, using band limited pink noise, then referred to 1 metre.
(4) Measured in half space at 2 metres using band limited pink noise, then referred to 1 metre.
(5) Measured on-axis in open (4π) space at 2 metres, then referred to 1 metre.
(6) Measured in open (4π) space at 2 metres with 1 watt input, using band limited pink noise, then referred to 1
metre.
Maximum SPL measured at 1 metre on axis shall be
125dB continuous, 131dB peak.
Dimensions (W) 620mm x (H) 243mm x (D) 400mm
(24.4ins x 9.6ins x 15.8ins).
(7) Measured in open (4π) space at 2 metres using band limited pink noise, then referred to 1 metre.
Weight 29kg (64lbs).
The loudspeaker system shall be the Martin Audio
W8LM.
Tr a d e D e s c r i p t i o n s A c t
Due to Martin Audio’s policy of continuing improvement, we reserve the right to alter these specifications without prior
notice. Martin Audio is committed to refining state of the art sound reinforcement, combining in-depth product and field
applications research with advanced manufacturing techniques. Every Martin Audio product is built to the highest
manufacturing standards and rigorously tested to ensure that it meets the performance criteria specified in the design.
Century Point, Halifax Road, Cressex Business Park,
High Wycombe, Buckinghamshire HP12 3SL, England.
Telephone: +44 (0)1494 535312 Facsimile: +44 (0)1494 438669
E-mail: [email protected]
All information is Copyright © 2006 Martin Audio Ltd.
5 of 5
|