Linear Telephone PD 2 User Manual

1. PRODUCT DESCRIPTION  
2. DIALER FEATURES & SYSTEM OVERVIEW  
3. FILL IN FACEPLATE CARD  
The 2-channel Model PD-2 Professional Voice Dialer is designed to connect to security or  
personal emergency systems. Two voice messages (each up to 10 seconds long) can be  
recorded into the dialer’s digital memory. Each dialer channel can dial up to four telephone  
numbers to play its message. The PD-2 can also be used to dial pager numbers and send  
numeric messages. Nine to 16 VDC power for the dialer is supplied from the triggering device.  
PD-2  
2-CHANNEL  
PROFESSIONAL  
VOICE  
DIALER PLUGS  
INTO A TELEPHONE  
WALL JACK  
ON THE FACEPLATE CARD  
SUPPLIED, FILL IN THE NAMES  
AND TELEPHONE NUMBERS OF  
THE PEOPLE THAT THE DIALER  
WILL CALL  
When triggered (by grounding one of the two inputs), the dialer begins its communication  
sequence. After a 15 second delay, the dialer will attempt to call the first telephone number  
programmed for the channel triggered. The dialer will go “off-hook” and try to detect a dial tone.  
After the dial tone is detected, the unit willstartdialing. Ifnodialtoneisdetectedforfiveseconds,  
the dialer goes “on-hook”, waits for three seconds; goes “off-hook”, then tries to detect a dial  
tone again. If no dial tone is detected on the second try, the call to the first telephone number  
is aborted and the dialer will attempt to call the next telephone number.  
TELEPHONE  
TELEPHONE LINE  
UP TO FOUR TELEPHONE  
NUMBERS CAN BE PROGRAMMED  
FOR EACH DIALER CHANNEL  
CORD PLUGS  
PLUGS INTO  
INTO VOICE  
DIALER'S  
DIALER'S PHONE  
LINE JACK  
JACK  
TELEPHONE  
MICROPHONE  
DIALER  
In the case of a false alarm, the 15 second start-up delay gives the user time to cancel the  
message before it’s sent by pressing the dialer’s STOP button. The start-up delay can be set  
for 0, 15, 30, 60 or 120 seconds. The 120 second delay option allows the dialer to be used for  
redundant voice reporting on the same system and telephone line with a faster triggering digital  
communicator.  
DIALER INPUT WIRE  
FOR POWER AND TRIGGER  
CONNECTS TO THE  
DIALER'S CONSOLE JACK  
PLACE THE CARD ON THE  
DIALER, THEN SECURE IT  
WITH THE CLEAR PLASTIC  
RETAINER  
Installation  
Instructions  
Five seconds after dialing, the unit begins playing the voice message for the channel triggered.  
The message repeats for 60 seconds. During the message, the dialed party can stop the  
communication sequence and prevent the dialer from calling the next telephone number by  
pressing any key on their telephone keypad. If a pager number is programmed, no voice  
message is played for that telephone number.  
PD-2  
DIALER  
THE DIALER CAN BE  
WALL MOUNTED OR USED  
ON A TABLE TOP (APPLY  
FOUR PLASTIC "FEET"  
FOR TABLE TOP USE)  
With the listen-in option enabled, the dialed party can listen to the protected premises using  
the dialer’s built-in microphone. When the dialed party presses any telephone key during the  
message, the message will stop and the microphone will be switched on for 60 seconds.  
Pressing any key extends the time another 60 seconds, pressing 99 hangs up.  
(760) 438-7000 • FAX (760) 438-7043  
DIALER  
"IN-USE"  
ALARM  
CONTROL  
PANEL  
USA & Canada (800) 421-1587 & (800) 392-0123  
Toll Free FAX (800) 468-1340  
INDICATOR  
Other programmable options allow tone or pulse dialing, and disabling the dialed party  
communication stop feature.  
4. PLUG TELEPHONE INTO DIALER (OPTIONAL) 5. CONNECT & WIRE DIALER INPUT  
6. PROGRAM VOICE MESSAGES  
7. PROGRAM PHONE OR PAGER NUMBERS  
START HERE  
START HERE  
PRESS THE PROGRAM BUTTON, THE RED LIGHT  
WILL TURN ON (THE RED LIGHT WILL BLINK ONCE  
AS EACH KEY IS PRESSED)  
CONNECTING A TELEPHONE  
TO THE DIALER IS OPTIONAL  
PRESS  
RED LIGHT TURNS ON  
PRESS 1~4 FOR CHANNEL #1, 5~8 FOR CHANNEL #2,  
TO SELECT THE TELEPHONE NUMBER TO PROGRAM  
WITH A TELEPHONE  
CONNECTED YOU CAN  
LISTEN TO THE DIALER AS IT  
MAKES ITS CALLS AND  
PLAYS ITS MESSAGE  
DURING SYSTEM TESTING  
PRESS  
PRESS  
RED LIGHT BLINKS ONCE  
SELECT CHANNEL #1 OR #2  
ENTER EACH TELEPHONE DIGIT, PRESSING THE DIAL  
BUTTON BEFORE EACH DIGIT. UP TO 30 DIGITS MAXIMUM.  
DIALING DELAYS: PRESSING DIAL TWICE ADDS A 2-SECOND  
DIALING DELAY, EACH TIME DIAL IS PRESSED IN SUCCESSION  
2 MORE SECONDS ARE ADDED TO THE DELAY. EACH DIALING  
DELAY USES UP A DIGIT.  
PLUG THE DIALER INPUT  
WIRE INTO THE DIALER'S  
CONSOLE JACK  
WIRES CAN BE  
ROUTED INSIDE THE  
WIRING TROUGHS  
IF REQUIRED  
OR  
RECORD  
YOUR  
ALARM  
FOR PAGERS: ENTER THE PAGER TELEPHONE NUMBER  
FIRST. USE DIALING DELAYS TO ALLOW TIME FOR THE  
PAGING SYSTEM TO ANSWER BEFORE THE NUMERIC  
MESSAGE IS SENT BY THE DIALER. PRESS DIAL TWICE  
AS THE LAST DIGIT OF THE NUMERIC MESSAGE TO  
PREVENT PLAYING THE VOICE MESSAGE.  
RED LIGHT ON DURING  
MESSAGE RECORDING  
(MESSAGE CAN BE UP  
TO 10 SECONDS LONG)  
JOE'S ALARM  
IS SOUNDING  
POWER INPUT + 9 TO +16 VDC  
20 mA IDLE, 100 mA OPERATING  
RED  
YELLOW  
GREEN  
BLACK  
CONNECT THE  
TELEPHONE  
TO THE DIALER'S  
PHONE JACK  
MESSAGE  
CHANNEL #1 TRIGGER  
SHORT-TO-COMMON TO ACTIVATE  
PRESS THE STOP BUTTON WHEN FINISHED  
RED LIGHT GOES OFF  
CHANNEL #2 TRIGGER  
SHORT-TO-COMMON TO ACTIVATE  
AT END OF  
MESSAGE  
PRESS  
DIALER INPUT WIRE  
RED LIGHT TURNS OFF  
TO ERASE A NUMBER: PRESS PROG, 1~8, DIAL, STOP  
COMMON POWER NEGATIVE  
WARNING: IT IS ILLEGAL TO PROGRAM THIS DIALER  
TO DIAL POLICE OR FIRE EMERGENCY NUMBERS DIRECTLY  
8. PLUG PHONE LINE INTO DIALER  
9. TEST DIALER  
10. PROGRAMMABLE OPTIONS  
LINEAR LIMITED WARRANTY  
This Linear product is warranted against defects in material and workmanship for twelve (12) months.  
The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale  
customers who buy direct from Linear or through Linears normal distribution channels. Linear does not  
warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature  
of the dealers warranty, if any. There are no obligations or liabilities on the part of Linear corporation  
for consequential damages arising out of or in connection with use or performance of this product  
or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal,  
installation, or reinstallation. All implied warranties, including implied warranties for merchantability and  
implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This  
Linear Corporation Warranty is in lieu of all other warranties express or implied.  
DIALING TYPE  
AUDIO LISTEN-IN  
TRIGGER THE DIALER  
1
PLUG ONE END OF THE  
AFTER 15 SECONDS, THE DIALER'S RED LIGHT WILL  
TURN ON AND THE CALL SEQUENCE FOR THE  
TRIGGERED CHANNEL WILL BEGIN  
2
TELEPHONE LINE INTO  
THE TELEPHONE  
WALL JACK  
TONE DIALING (DEFAULT)  
DISABLE AUDIO LISTEN-IN (DEFAULT)  
PICK UP THE TELEPHONE HANDSET TO MONITOR THE  
PROGRESS OF THE CALL(S)  
3
4
PRESS ANY KEY ON THE TELEPHONE (OR PRESS AND  
HOLD THE DIALER'S STOP KEY) TO DISCONNECT THE  
DIALER AND STOP ITS CALL SEQUENCE  
All products returned for warranty service require a Return Product Authorization Number (RPA#).  
Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.  
PULSE DIALING  
ENABLE AUDIO LISTEN-IN  
FCC NOTICE  
This equipment generates and uses radio frequency energy and if not installed and used properly,  
that is, in strict accordance with the manufacturers instructions, may cause interference to radio and  
television reception. It has been type tested and found to comply with the limits for a Class B computing  
device in accordance with Part 15 of FCC Rules, which are designed to provide reasonable protection  
against such interference in a residential installation. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause interference to radio or television  
reception, which can be determined by turning the equipment off and on, the user is encouraged to  
try to correct the interference by one or more of the following measures:  
DIALING TONES  
AND RECORDED  
MESSAGE  
DIALING DELAY  
CALL ACKNOWLEDGE  
0
SECONDS  
TO  
TRIGGERING  
DEVICE  
15  
SECONDS  
(DEFAULT)  
HANG UP OR LISTEN-IN WHEN ANY  
TELEPHONE KEY IS PRESSED (DEFAULT)  
Relocate the dialer away from the TV/radio receiver.  
Plug the dialer into a different wall outlet so that the dialer is on a different branch circuit.  
Re-orient the TV/radio antenna.  
If necessary, the user should consult the dealer or an experienced radio/television technician for  
additional suggestions.  
30  
SECONDS  
60  
PLUG THE OTHER END  
OF THE TELEPHONE  
LINE INTO THE DIALER'S  
LINE JACK  
SECONDS  
RED DIALER  
"IN-USE" INDICATOR  
Changes or modifications to the device may void FCC compliance.  
CALL ALL NUMBERS REGARDLESS  
IF ANY TELEPHONE KEY IS PRESSED  
PRESS ANY KEY  
TO STOP THE DIALER  
120  
SECONDS  
Copyright © 2000 Linear Corporation  
214619 A  
 

Kyocera Digital Camera SL300R User Manual
Lego Games 10572 User Manual
LG Electronics Cell Phone 200C User Manual
Life Fitness Stepper Machine LS 5500 User Manual
Linksys Network Router AM200 User Manual
Magnavox Portable Radio AE 6360 User Manual
Manitowoc Ice Air Compressor C 0200 User Manual
Marantz Projector VP 12S1s User Manual
Maytag Range 8113P424 60 User Manual
MicroNet Technology Switch SP616DB User Manual