Model PRO744
Rechargeable Nickel Metal-Hydride
Charger and Batteries
Owner’s Manual
Thank you for purchasing the NoMEM PRO Battery System. Please read this manual carefully. It contains important
operating instructions for your NoMEM PRO Rechargeable Battery System. This PRO744 charger will quickly and
efficiently charge all AA or AAA Nickel Cadmium (NiCd) or Nickel Metal-Hydride (NiMH) batteries.
Warning:
•
•
•
Batteries are not charged as shipped. Must be charged prior to first use.
Charge only NiCd or NiMH type batteries on this charger.
Do Not mix NiCd and NiMH batteries together when charging or using. Keep all NiMH batteries and NiCd batteries
separate.
•
•
Use only NoMEM PRO or other proper NiMH compatible charger to recharge NoMEM PRO batteries.
Batteries may leak or explode causing personal injury if inserted improperly, disposed of in fire, mixed with other
battery types, or short circuited.
CHARGING INSTRUCTIONS
AA and AAA Size (Automatic Quick Charge)
1. This charger will charge 2 or 4 batteries at one time. Slide the switch above the battery compartment to the “2” or “4”
position according to the number of batteries you wish to charge. When charging 2 batteries only, use the left side of
the battery compartment, leaving the 2 spaces on the right side empty. When charging 4 batteries, slide the switch to
the “4” position and insert all 4 batteries to be charged (see figure 1).
2. The battery compartment is adjustable to fit either AA or AAA size batteries. If you are charging AAA size batteries,
make sure the handle at the top of the battery compartment has been moved all the way down until it has clicked into
place. If you are charging AA size, make sure the handle is lifted all the way up into the notch located at the top of
the battery compartment. After adjusting the compartment to fit the size batteries you wish to charge, insert either 2
or 4 AA or AAA batteries into the charger. Do not mix AA and AAA batteries when charging.
3. Select the AC adapter or DC/Auto Cord adapter, depending on whether you are using the charger at home or in the
car. Be aware that when using the DC/Auto cord, many cars do not supply power to the cigarette lighter while the key
is in the off position. Plug the selected power adapter into the power source available, and plug the connector, at the
end of the adapter cord, into the power input jack on the top of the charger unit. The red “Charge” indicator LED will
glow Red to show charging is taking place.
4. After the proper charge time, the red “Charge” LED will go off and the Green “Ready” LED will come on to indicate
that the charge is complete and batteries are ready for use. Once the green “Ready” LED is on, the charger switches
to “trickle” mode to keep the batteries at full.
5. Once charge is complete, remove batteries and unplug charger as soon as it is practical. Do not leave batteries in
charger for extended periods of time (more than 1-2 days) OR when the charger is not plugged in. Unplug the
charger when not in use.
6. Begin again at Step-1 to charge the next set of batteries.
Bad Cell Detection:
When charge process is started, the charger detects the health status of each of the cells in the battery compartment. If
any battery is unsuitable for charging, i.e. short circuit or reversed polarity, the red “Charge “ LED will flash. The damaged
cell(s) should be properly disposed of.
|