PW-USBACDC
User Manual
Dual Ports
USB CHARGER
Please read carefully before use
For technial support please visit
Address: Unit 1, 6-8 Byfield St, North Ryde, NSW 2113 AUSTRALIA
PW-USBACDC User Manual
TECHNICAL SPECIFICATIONS
COMPONENTS IN THE BOX
> AC input: 100VAC~240V AC 50/60Hz
> DC input: 12VDC~24VDC
AC plug
Australia / New Zealand 240v AC plug
> Rated output: 5V DC (standard)
> USB 1 and 2 ports: 0.5A max current
> SIZE:18X18X5.5( L X W X H )
> WEIGHT:260g
Charger body
100v - 240v transformer (self switching)
12v DC Car (Cigarette socket) adaptor
DC plug
TROUBLESHOOTING
USB connectors (x 2)
Twin USB ports for charging
> Voltage of device does not correspond with that of USB adapter (5v; 0.5A per
device)
Refer to the user manual that came with your device.
> Improper connection between your device and the USB adapter.
Make sure that the USB cable has the correct plug and is properly inserted into the
device and the USB adapter.
FEATURES
> Charge almost any 5V USB device such as iPod ™, digital cameras, MP3/ 4 players or
mobile phones that charge using a USB cable.
> Simply plug into any wall (240v) or car (12vDC) socket and start charging.
> Convenient slimline design.
> Device is not charging
Some products require a PC or dedicated verification signal for battery charge &
may need a PC to charge.
> Two USB sockets for increased versatility
> Can not charge with car kit plug in the car
IMPORTANT SAFETY INSTRUCTIONS
> Read and observe all warnings on the USB charger and in this user manual .
> Devices connected to the USB charger should not exceed 5.3Volts
> Do not use the USB charger in the moist places or close to water.
> Safe operating environment: 0 to 45 degrees Celsius
Check the in built fuse in the DC plug and replace if necessary / check ignition on or
vehicle fuse.
WARRANTY
> 1 year limited warranty
OPERATION
> Warranty does not cover owner’s negligence, accidental damage, misuse, normal
wear and tear
> Select either AC (100-240VAC) plug or DC (12-14vDC) plug to be used
> Connect the USB device(s) to one or both of the USB output terminals
> Charging will commence immediately (no switches required)
1
2
|