La Crosse Technology Clock WT 9300 User Manual

Topic  
Page  
WT-9300  
Radio-controlled  
Travel Alarm Clock  
Inventory of Contents  
About WWVB  
2
2
Program Mode  
Initial Set-up  
2
4
5
5
6
6
7
7
8
8
8
Manual Time Setting Option  
Time Zone Setting  
Daylight Savings Time (DST)  
Display Mode Setting  
Setting the Alarm  
Instruction Manual  
S
N
O
O
Z
E
Operating the Alarm and Snooze  
Troubleshooting  
Maintenance and Care  
Specifications  
Warranty Information  
FCC ID: OMO-01RX  
THIS DEVICE COMPLIESWITH PART 15 OFTHE FCC  
RULES. OPERATION IS SUBJECT TO THE  
FOLLOWING TWO CONDITIONS:  
N
E
A
A
I
L
/
/
M
L
E
H
D
R
O
M
R
R
D
I
O
C
O
N
T
R
O
L
D
1. THIS DEVICE MAY NOT CAUSE HARMFUL  
INTERFERENCE, AND  
R
2. THIS DEVICE MUST ACCEPT INTERFERENCE  
RECEIVED, INCLUDING INTERFERENCE THAT  
MAY CAUSE UNDESIRED OPERATION.  
P.1  
GB  
and set. Adverse weather conditions may also affect  
the travel alarms’ ability to receive the signal. In some  
cases it may take several nights for the travel alarm to  
set.  
rear of the travel alarm shown in figure one.  
Press and release the “Snooze” button to return the  
normal display mode or wait 20 seconds and the travel  
alarm will time out and automatically return to the  
normal display mode.  
INVENTORY OF CONTENTS  
1. The travel alarm  
2. Instruction manual  
3. Warranty card  
Figure One  
Manual Time Setting Option  
Time Zone Setting  
ABOUT RADIO-CONTROLLED TIME - WWVB  
The NIST (National Institute of Standards and  
Technology-Time and Frequency Division) WWVB radio  
station is located in Ft. Collins, Colorado, and transmits  
the exact time and date signal continuously throughout  
the United States at 60 kHz. The signal can be received  
up to 2,000 miles away through the internal antenna in  
the alarm clock. Due to the nature of the Earth’s  
Ionosphere, reception is very limited during daylight  
hours. The alarm clock will search for a signal every  
night when reception is best. The WWVB radio station  
derives its signal from the NIST Atomic clock in Boulder,  
Colorado. A team of atomic physicists is continually  
measuring every second, of every day, to an accuracy  
of ten billionths of a second per day. These physicists  
have created an international standard, measuring a  
second as 9,192,631,770 vibrations of a Cesium-133  
atom in a vacuum. More information on the atomic clock  
You can also manually set the time on your travel alarm  
by pressing and holding the “MODE/MIN” button (figure  
two) on the front of your travel alarm for 3 seconds.  
You can select from four U.S. time zones (Eastern,  
Central, Mountain and Pacific) on your travel alarm. The  
time zones are abbreviated with three letters as follows:  
SIZE AA LR6  
+
S
N
O
O
Z
E
Eastern  
Central  
Mountain  
Pacific  
EST  
CST  
MST  
PST  
Next insert one AA alkaline battery into the battery  
compartment making sure to observe the correct  
polarity.  
Press and hold the “MODE/MIN” button for 3 seconds.  
The time zone abbreviation will appear in the LCD.  
When inserting the battery be sure not to press any  
of the buttons on the travel alarm as this will interrupt  
the WWVB search and may cause the travel alarm  
to not pick up the radio-controlled time signal.  
Now replace the battery cover and face the travel  
alarm with the back of the unit towards Colorado (this  
has been found to help the unit pick up the WWVB  
signal).  
NOTE:The default (factory) time zone setting is Eastern  
time zone.  
A
A
I N  
L
/
/
M
L
HR  
DE  
M O  
Press and release the “AL/HR” button to select the  
desired time zone.  
Press and release the “Snooze” button twice to return  
to the normal display mode or wait 20 seconds and  
the travel alarm will time out and automatically return  
to the normal display mode.  
R
R
D
I
O
C
O
N
T
R
O
L
E
D
The time zone abbreviation will appear in the LCD.  
Press and release the “Snooze” button once.  
The time will now flash in the LCD.  
Press and release the “AL/HR” button to advance the  
hours.  
When the WWVB signal is received a tower icon will  
appear on the left side of the LCD display.  
PROGRAM MODE  
Following is a list of steps to set up your new La Crosse  
Technology travel alarm clock.  
Daylight Saving Time Setting  
You can select whether or not your alarm recognizes  
the daylight saving time changes twice a year and  
automatically changes. Some areas do not change time  
Press and release the “MODE/MIN” button to advance  
the minutes.  
NOTE: Due to the nature of the WWVB signal it may  
take overnight for the travel alarm to receive the signal  
Please begin by removing the battery cover on the  
P.4  
P.5  
P.2  
P.3  
 
GB  
GB  
GB  
GB  
for daylight saving time (Arizona and parts of Indiana).  
The default (factory) setting is daylight saving time on.  
Press and release the Snoozebutton to return to  
the normal display mode or wait 20 seconds and the  
travel alarm will time out and automatically return to  
the normal display mode.  
take up to 72 hours before a good signal is received.  
The reception can be helped by placing the clock in a  
window facing Colorado, with the back towards  
Colorado.  
Press and hold the MODE/MINbutton for 3 seconds.  
The time zone abbreviation will appear in the LCD.  
DSTwill be displayed to the left of the time zone  
abbreviation.  
Operating the Alarm and Snooze  
MAINTENANCE AND CARE INSTRUCTIONS  
To turn the alarm on press and release the AL/HR”  
button. The alarm icon will be displayed in the lower  
right of the LCD to indicate that the alarm has been  
turned on.  
Extreme temperatures, vibration, and shock should  
be avoided to prevent damage to the unit.  
Clean displays and units with a soft, damp cloth. Do  
not use solvents or scouring agents; they may mark  
the displays and casings.  
Press and release the MODE/MINbutton to toggle  
between daylight saving time on and off.  
Press and release the Snoozebutton twice to return  
to the normal display mode or wait 20 seconds and  
the travel alarm will time out and automatically return  
to the normal display mode.  
The alarm will sound for 100 seconds once activated.  
By pressing the snooze button the alarm will be  
suspended for 8 minutes.  
Do not submerge in water.  
Do not subject the units to unnecessary heat or cold  
by placing them in the oven or freezer.  
Opening the casings invalidates the warranty. Do  
not try to repair the unit. Contact La Crosse  
Technology repairs.  
Display Mode Setting  
The display below the time can be switched between  
showing the seconds and the alarm time. To switch  
between these two modes press and release the MODE/  
MINbutton.  
TROUBLESHOOTING  
NOTE: For problems not solved, please contact La  
Crosse Technology via e-mail or phone, or visit our  
SPECIFICATIONS  
Dimensions:  
(L x W x H)  
Battery  
Battery life  
3" x 1.50" x 4.13"  
Setting the Alarm  
To set the alarm press and hold the AL/HRbutton for  
three seconds.  
(76 x 38 x 105 mm)  
One AA Alkaline Battery  
Approximately 1 year  
Problem: The time and date will not set initially.  
Solution: It usually takes overnight before the clock can  
receive the signal due to the interference the sun has  
on the WWVB signal. Wait overnight for the signal.  
Solution: Computer monitors and televisions can cause  
interference with the signal reception. Please keep the  
clock at least six feet from electrical sources.  
The alarm time will flash in the bottom left of the LCD  
screen.  
Press and release the AL/HRbutton to advance to  
the desired hour.  
Press and release the MODE/MINbutton to advance  
to the desired minute.  
WARRANTY INFORMATION  
La Crosse Technology provides a 1-year warranty on  
this travel alarm. Contact La Crosse Technology  
Solution: In some areas of the US, in particular on the  
East and West coasts, the signal is very weak. It may  
P.6  
Download from Www.Somanuals.com. PA.l7l Manuals Search And Download.  
P.8  
GB  
GB  
GB  
WARRANTY INFORMATION  
La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and  
workmanship.  
This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only  
to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for  
problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized  
service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La  
Crosse Technology, Ltd’s authorized service center.  
La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or  
reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and  
products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts  
and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all  
expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a  
product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any  
shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center.  
La Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only.  
Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1)  
damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage  
occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative  
surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the  
performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6)  
units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a  
signal due to any source of interference.. This warranty covers only actual defects within the product itself, and does not cover the cost  
of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or  
performance variations resulting from installation-related circumstances.  
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER  
SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO  
BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF  
CHILDREN’S REACH.  
This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the  
exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you.  
For warranty work, technical support, or information contact:  
La Crosse Technology, Ltd  
2809 Losey Blvd S.  
La Crosse, WI 54601  
Phone: 608.782.1610  
Fax: 608.796.1020  
e-mail:  
(warranty work)  
(information on other products)  
web:  
All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic,  
mechanical or chemical procedures without written permission of the publisher.  
This handbook may contain mistakes and printing errors. The information in this handbook is regularly checked and corrections made  
in the next issue. We accept no liability for technical mistakes or printing errors, or their consequences.  
All trademarks and patents are acknowledged.  
1
 

Laser MP3 Docking Station SPK IPT01 User Manual
LG Electronics Microwave Oven R 1830 User Manual
Link electronic Network Router 861 XL161J User Manual
Makita Saw 2704X1 User Manual
Marshall electronic Flat Panel Television V R84DP 2C User Manual
Martin Fireplaces Indoor Fireplace SB5400SS User Manual
Matsushita Laptop CF 18JHU80TW User Manual
Melissa Bread Maker 643 043 User Manual
Metrologic Instruments Scanner MS7120 Series User Manual
MidiLand Speaker System S4 3050M User Manual