CLEANING THE IMAGING GUIDE AND
PAPER SENSORS
SUPPLIES*
Kodak i30/i40 Scanners
CAT No.
Description
1. Remove dust and debris from this area by using a Stati-
cide wipe or a small brush. Be careful not to scratch the
glass when cleaning.
174 7849
Kodak Feed Module / for i30/i40
Scanners
853 5981
896 5519
Kodak Digital Science Roller Cleaning
Pads (qty 24)
2. Wipe the imaging guide with a Staticide wipe.
Reflector spot
Staticide Wipes for Kodak Scanners
(qty 144)
* Items are subject to change.
Imaging guide
.
IMPORTANT:Staticide wipes contain isopropanol which can
cause eye irritation and dry skin. Wash your
hands with soap and water after performing
maintenance procedures. Refer to the User’s
Guide for MSDS acquisition.
3. Wipe the imaging guide again with an almost-dry
Staticide wipe to remove any streaks.
Quick Tips
4. Clean the reflector spot using the almost-dry Staticide
wipe to remove any dust or streaks.
K NUMBER, SERIAL NUMBER AND DATA-
PLATE LOCATION
Kodak Service
1-800-822-1414
The K Number, Serial Number and Dataplate can be found
on the bottom of the scanner.
To access the dataplate:
Kodak Parts Services
1-800-471-0803
•
Carefully tilt the scanner back until you can see the
dataplate on the bottom of the scanner.
1-585-724-6042
Kodak Professional Services
1-800-525-6325
EASTMAN KODAK COMPANY
Document Imaging
Rochester, New York 14650
Serial number and
Dataplate
K number
Kodak and Digital Science are trademarks of Eastman Kodak Company.
© Eastman Kodak Company, 2004
A-61526
|