Input
MR164 Keypad
Operating
Instructions
Line 1
Line 2
select
button
LCD display
Volume UP
Volume
select
button
INPUT
VOL
M UTE
and DOWN or
source select or
sets backlighting
Congratulations and thank you for choosing this
Knoll product. The MR164 keypads can control the
GSZ67 controller-amplifiers. They are very easy-to-
use giving you top quality sound available in up to
six or more rooms.
Mute
Button
ALL
OFF
ALL button for whole
house functions
Shut off this room
or shut off whole
house (press for
5 seconds
Infrared
Receiver
The MR164 is available with two LCD colors, yellow-
green with black lettering and blue with white
lettering (model MR164b). Both versions are
available with Decora™ style bezel plates in white,
almond, black or ivory colors.
Adjusting Backlighting. MR164’s are backlit for
easy nighttime operation. To
adjust the backlighting make
sure the power for the keypad is
on and the MR164 is displaying:
System
Off
The music system consists of:
Without pressing any other buttons press the UP or
DOWN button to increase or decrease the
backlighting illumination. The level selected will
remain in the memory even if the power is
disconnected.
1. Rooms with stereo speakers, a MR164 keypad or a
third party whole house controller and possibly a
remote control.
2. One or more GSZ67 controller-amplifiers.
Turning on a source to this room with the
MR164 keypad. After the system is completely
installed, if the system is not yet turned on, turn the
sources on and then turn the GSZ67 controller
amplifier using the front power button on the GSZ67.
3. Stereo source components such as tuners, CD
players, satellite dish receivers, cassette decks, and
other components.
While the MR164 evolved after years of research, its
use is straightforward and direct. Some rooms may
have more than one pair of speakers and one or two
MR164 keypads or possibly even no keypad.
After power has been turned on
the MR164 keypad will display its
software revision followed by
“Knoll Systems” and then:
System
Off
The music system is controlled by the MR164
keypads, RB12 or universal remote, the source
components and possibly a whole home controller.
The source components are controlled by their
individual remote controls by aiming the remote
control at the keypad or infrared receiver and
pressing the appropriate remote control button.
To turn a source on in this room press the INPUT
button. The volume is always set at about 30% when
the room speakers are first turned on. This room will
always revert to the source it was switched to when
it was turned off last time. To change to another
source, see changing sources below.
Turn on a source in this room using the RB12
Remote Control. To turn on a source in this room
using the RB12 remote control press the RB12
remote control 1, to 7 button corresponding to
which source you want to listen to. You do not need
to press the POWER button on the remote first.
Please read about the GSZ67 with the manual
shipped with that product.
MR164 Keypad Operation
The MR164 keypad is relatively easy to operate and
within a short period of time should be very intuitive.
Whole house source selection is not available from
the RB12 remote.
Please ensure that keys are not pressed too fast as
the controller or keypad may be confused. If this
happens reset the system powering it off and then
on again.
|