SB-F-ESCP/10W1V2 INSTR_SKU# 011286
InstallatIon
d I F F I C u lt Y :
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
out
oF
I n s t a l l a t I o n G u I d e
for the
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
35
SB-F-ESCP/10W1v2
sKu#94440
Ford escape, Mazda tribute - 2001+
Mercury Mariner - 2005+
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
estIMated tIMe:
2-3 HouRs
s t e P
1
Remove the cover in front of the pocket as shown.
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
s t e P
2
This is how it looks after removing the cover.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
s t e P
3
Remove the woofer from the Stealthbox®. Hold the
enclosure in place and use a marker to mark the interior
panel through the hole in the back of the Stealthbox®
Continued on Next Page
SB-F-ESCP/10W1V2 INSTR_SKU# 011286
s t e P 1 0 d e t a I l ( 2 )
I n C l u d e d H a R d W a R e
VIEWED FROM ABOVE LOOKING DOWN
This is how the hardware should be configured for the
bracket and, the Stealthbox®.
VEHICLE SHEET METAL
2) 1/4-20 x 1 1/4” Hex Head Bolt
2) 1/4” Split Lock Washer
1) 3/8” Split Lock Washer
1) 3/8-16 x 2 1/4” Allen Head Stud
1) Custom Mount bracket
2) 1/4-20 Hex Hed Nut
2) 1/4” Flat Washer
1) 3/8” Flat Washer
1) 1” Spacer
FLAT WASHER
SPLIT LOCK WASHER
INTERIOR PANEL
SPLIT LOCK WASHER
ALLEN HEAD STUD
HEX NUT
MOUNTING BRACKET
1”SPACER
HEX NUT
FLAT WASHER
HEX HEAD BOLT
s P e C I F I C a t I o n s
STEALTHBOX WALL
VEHICLE SHEET METAL
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 10w1v2-4
Nominal Impedance: 4 ohms
Continuous Power Handling: 300watts
s t e P 1 1
Expand the round hole in the interior panel from steP 4
as shown, re-install all of the the interior panels that were
removed earlier, place the 1” Spacer (included) over the Stud
as shown.
P o W e R R e C o M M e n d a t I o n
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1v2
when being used to power your Stealthbox®.
s t e P 1 2
Put the box in the panel and line it up with the bolt. Make
sure to run speaker wire from the enclosure to the location of
the amp before securing it to the vehicle.
The JL Audio 250/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
M I d / H I G H F R e q u e n C Y d R I v e R F I t M e n t
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors
Fits JL Audio Models: TR570-CXi, C5-570, C5-570x & ZR570-CSi
Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door
Fits JL Audio Models: TR570-CXi, C5-570x
s t e P 1 3
Mount woofer to the box . place grill over the speaker,
secure the woofer and you are done.
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
(954) 443-1100
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011286 01-22-2009
•
Printed in USA
•
©2008 JL Audio, Inc. U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
•
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
Page 5• JL Audio, Inc 2008
|