Back Extension - InvacareTracer SX,9000,and XT
Assembly,Installation and Operating Instructions
Back
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage before using.
In case of damage, DO NOT use the equipment. Contact
the Dealer/Carrier for further instructions.
DETAIL “A”
Upholstery
Washer
Mounting Holes
Mounting
Screws
SAFETY SUMMARY
The following recommendations are made for the
safe use of the Back Extension:
Back Upholstery
DETAIL “B”
GENERAL WARNING
Back Cane
DO NOT insta ll or use this e quipme nt without
first re a d ing a nd und e rsta nd ing the se
instruc tions. If you a re una ble to unde rsta nd
the Wa rning s, Ca utio ns o r Instruc tio ns,
c o nta c t a he a lthc a re p ro fe ssio na l, d e a le r
o r te c hnic a l p e rso nne l b e fo re a tte m p ting
to insta ll this e q uip m e nt - othe rwise , injury
o r d a m a g e m a y o c c ur.
Back Extension
Bracket
Upper Mounting
Hole
Lower Mounting
Hole
Mounting
Screws
Washer
FIGURE 1 - INSTALLING THE BACK
EXTENSIO N BRAC KETS
INSTALLATION WARNING
Afte r ANY a djustme nts, re pa ir or se rvic e a nd
BEFORE use , m a ke sure tha t a ll a tta c hing
ha rd wa re is tig hte ne d se c ure ly.
INSTALLING THE BACK EXTENSION
(FIGURE 2)
This kit includes the following:
1. Alignthebackextensioninserttubeswiththebackexten-
sion brackets on the wheelchair as shown in FIGURE 2.
ITEM
QUANTITY
Back Extension Brackets
Back Extension
Mounting Screws
Washers
2
1
2
2
NOTE:Fasteningstripsshouldfacetherearofthewheelchair.
2. Seat the insert tubes firmly into position in the back
extension brackets.
INSTALLING THE BACK EXTENSION
BRACKETS (FIGURE 1)
NOTE:Makesurethatthewheelchairisunfoldedonalevel
surface, with the wheel locks engaged.
NOTE:Alignmentnotchesshouldsitfirmlyonthealignment
screws. Insert tubes should NOT rotate in back extension
brackets.
Fastening Strips
Back Extension
Insert Tube
1. Remove the upper two (2) mounting screws and
washers securing the back upholstery. Refer to
DETAIL“A”inFIGURE1.
Back Extension
2. Align the upper and lower mounting holes in the back
extension brackets with the upper two (2) mounting
holesinthebackupholsteryandbackcanes. Referto
DETAIL “B” in FIGURE 1.
Insert Tube
Alignment
Notch
Alignment
Notch
NOTE: The back extension brackets accommodate several
models of chairs, replace only the mounting screws that are
removed. An extra set of screws is included for instances
of loss or damage.
Alignment
Alignment
Screw
Screw
3. Install the two (2) existing mounting screws and washers
as shown in DETAIL “B”. Tighten securely.
Back Extension Brackets
4. Repeat for opposite side.
FIGURE 2 - INSTALLING THE BACK EXTENSION
Invacare Corporation
USA
Canada
One InvacareWay
Elyria,Ohio USA
44036-2125
5970 ChedworthWay
Mississauga, Ontario
L5R 3T9, Canada
905-890-8838
Invacare and "Yes,you can" are trademarks of Invacare
Corporation.
© 2000 Invacare Corporation
800-333-6900
Form No. 00-107 Part No. 1098351 RevA (1) 6/00
|