Installation of Rectangular Pan Holder and Pan
Assembly,Installation and Operating Instructions
MODEL Nos. 9640-4, 9640-1, 9630-4, 9630-1, 9620-4, 9620-1, 9610-4 and 9610-1
4. Slide the remaining bracket up and over the remaining
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage before using.
In case of damage, DO NOT use the equipment. Contact
your Dealer/Carrier for further instruction.
portion of the existing pail hanger. Open end of pan
holder should face to the rear of the commode.
5. Ensure that it is properly situated onto existing pail
hanger.6. InstallNEWrectangularpanontotheNEW
pan holder from the rear of the commode by sliding
the back end of the lipped top of the rectangular pan
onto the NEW pan holder rails and push it forward.
SAFETY SUMMARY
Thefollowingrecommendationsaremadeforthesafe
andproperinstallationanduseoftheRectangularPan
Holder and Pan:
7. To remove pan and pan holder, reverse STEPS 3-6.
GENERAL WARNING
Existing Pail
Hanger
DO NOTinstalloruse thisequipmentwithoutfirstread-
ing and understanding this instruction sheet. If you
are una ble to understa nd the Warnings, Cautions
and Instructions, contact a healthcare professional,
dealer or technical personnel before a ttempting to
install this equipment - otherwise, injury or damage
may occur.
Before using the commode: Always test to see that
all parts of the commode are secure. Make certain
ALL screws, nuts a nd/or bolts a re tight a t a ll times.
Install Pan Holder
Users with limited physica l ca pa bilities should be
supervised ora ssisted when utilizing the commode.
The a pplica ble commodes listed ha ve a weight
limitation of 300 lbs. (135 kg.). The Extra Wide Com-
mode ha s a weight limita tion of 450 lbs. (202.5 kg.).
INSTALLATION WARNING
AfterANYadjustments, repairorservice and BEFORE
use, ma ke sure tha t a ll a tta c hing ha rdwa re is
tighte ne d se c urely.
Existing Pail
Hanger
Install Pan to
Pan Holder from
Rear of Commode.
INSTALLING RECTANGULAR PAN
HOLDER AND PAN ONTO EXISTING
STANDARD COMMODE PAIL
HANGER (FIGURE 1)
Back Rail of Commode
1. Remove original commode lid from commode by
grasping and pulling straight up.
2. Remove existing commode seat by grasping and
pulling straight up.
FIGURE 1 - INSTALLING RECTANGULAR PAN
HOLDER AND PAN ONTO EXISTING
3. Install the rectangular pan holder onto existing
commode pail hanger framework by placing bracket
of one side over the existing pail hanger.
STANDARD COMMODE PAIL HANGER
INVACARE CORPORATION
899 Cleveland St. l Elyria, Oh. 44036-2125 l Customer Service - Toll Free (800) 333-6900
Form No. 97-105
P/N 1069323
Printed in USA
|