TM
D e s c r ip t io n
The MD-CC1 0 0 -0 0 0 Parameter Setup Cable eliminates
the need for the user to wire communications to the IMS
product. Included in this cable is built-in logic level shifting
circuitry to accommodate the 3 .3 v ports on some PCs.
in t e l l ig e n t m o t io n s y s t e m s , in c .
Excellence in MotionTM
This cable plugs in easily to connect a standard DB-2 5
PC Parallel/ SPI port to the 1 0 pin header.
MD-CC100-000
Parameter Setup Cable
S P I P in A s s ig n m e n t s
10 Pin Header
Pin #
1
2
Pin Name
N/C
Description
No Connect
No Connect
N/C
3
N/C
No Connect
4
CS
Chip Select
5
6
7
8
GND
+5VDC
MOSI
CLK
Communications Ground
+5VDC Output (See Warning Below)
Master Out – Slave In
Clock
9
N/C
No Connect
10
MISO
Master In – Slave Out
WARNING! The +5VDC output is used for the setup cable
ONLY! This output is not designed to power external devices!
370 N. MAIN ST., PO BOX 457, MARLBOROUGH, CT 06447
PH: (860) 295-6102, FAX: (860) 295-6107
WARNING! DO NOT connect or disconnect the MD-CC100-000
Parameter Setup Cable while power is applied!
S P I In t e r f a c e
P a r a m e t e r S e t u p C a b l e U s a g e
The MD-CC1 0 0 -0 0 0 Parameter Setup Cable is designed to be
used with the following IMS products:
PIN 4 - CS
GND - PIN 5
MOSI - PIN 7
PIN 6 - +5VDC OUT
PIN 8 - CLOCK
MDrive1 4 *
PIN 10 - MISO
MDrive1 7 Microstepping* and Speed Control Versions
MDrive2 3 Microstepping* and Speed Control Versions
MDrive3 4 Microstepping and Speed Control Versions
USC-4 8 -2 Universal Speed Control
DB-25 Standard
PC Parallel/SPI Port
10 Pin Header
P2
2
3
4
19
15
Ground
*
The MDrive1 4 , MDrive1 7 C and MDrive2 3 C are equipped with C Connector and
require an Adapter Cable to interface with the MD-CC1 0 0 -0 0 0 . The optional
Prototype Development Cable is also recommended for these products.
For More Information:
See each product’s complete manual
on the IMS Product CD or at www.ims home.com
D e t a il s
To Customer PC
Parallel/SPI Port
Pin 1
To 10 Pin Header
Pin 2 - SPI Clock
Pin 3 - MOSI
Red Wire
# 1 Pin
Pin 15 - MISO
Pin 4 - SPI Chip Select
Pins 18-25
Ground
Cable Length
6 Feet (1.8 M)
Standard DB-25
Parallel/SPI Connector
Revision 102104
Copyright © 2003–2004 Intelligent Motion Systems, Inc.
|